answersLogoWhite

0

The filter is made for more than one application, the old filter had to have some kind of seal on it or the oil would have leaked out. Match one of the new o rings up to the old one and use it on the new filter. Buy oem parts next time and you wont have this problem.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where do you get Hayward pool filter instruction manuel?

where can i find a manual for a swim pro sand pool filter s48c 51201?


How do you replace the fuel filter located on firewall of a 1986 Honda Civic Si?

Release the pressure from the system by loosening the top nut. Then just loosen the nut for in and out. Make sure you replace the washers. I believe there are three washers.


How do I replace a WF50 water filter?

The filter should be changed every 12 months. To find out how to do that you will need the instruction manual which can be ordered from the manufacturer if you no longer have it.


Which filter connection types uses a hollow bolt and sealing washers?

The filter connection types that use a hollow bolt and sealing washers are typically referred to as "hollow bolt" or "hollow mounting" connections. These connections provide a secure and leak-proof attachment for filters, commonly found in hydraulic systems or applications where fluid containment is critical. The hollow bolt allows fluid to flow through the center while the sealing washers ensure a tight seal around the connection.


How do you replace a fuel filter on a 1995 suzuki sidekick?

1: depressurize lines. 2: unbolt filter(use 2 wrenches at same time) 3: put in new filter and new washers. 4: start car. http://www.kick-fix.com/INJECTORS/depressure.html


Why don't hot water run into washer?

Probably because you have a plugged inlet filter. All washers have this tiny filter inside the inlet hose. -Another possible reason is the electrically controlled inlet valve, it may fail .


Where is oil filter located on a 2005 dodge magnum?

On a v6 it is located on the passenger side of the motor near the front on the bottom. be sure that the washer on the oil filter comes off with the filter, or there could be an oily mess. For some reason these washers like to stick. Not sure about v8 location


How do you repaire protonwira air filter?

You go to the where you bought the car from and you get them to do it. It is very complicated. :)


How do you replace the fuel filter on a Buick LeSabre?

How do you replace fuel filter on 1993 Buick LeSabre, the replacement filter I bought appears to be a snap on. I have only replaced the screw on type.


Will a GE GSWF filter fit my French door refrigerator?

No. The filter from your old refrigerator will not work with the new refrigerator that you bought. They are totally different models so you will have to purchase a new filter.


Is there a filter on the Kenmore washer HE2?

Yes, the Kenmore washer HE2 has a filter, but it's not a traditional lint filter like those found in older washers. Instead, it has a drain pump filter that helps catch debris and prevent clogs. This filter is typically located at the bottom front of the washer and should be cleaned periodically to ensure optimal performance. Always refer to the user manual for specific instructions on how to access and clean the filter.


How do you replace the fuel filter located on a 1993 Toyota truck?

You buy a new one at say autozone and the fuel filter is located inside the engine compartment on the passenger side just unscrew the fuel lines and un bolt the old filter and replace with the new one using the washers supplied in the box