answersLogoWhite

0

cracked gas line, cracked bulb, or weedeater out of gas

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you prepare a wall to be painted?

Clean it, fill any minor holes, then primer it.


Is the primer bulb on a 6.5 HP Briggs engine supposed to be fill with gas or air?

The primer on a 6.5 hp Quantum or Intek Briggs and statton engine is an air chamber that when you press it pushes air through the carby bowl and forces a small amount of fuel(gas) up through the main jet and into the intake system.


How many gallons of gas does it take to fill a whole tank of gas?

11.6 for Toyota Echo


You recently bought a camaro that has been primered Will you need to strip off the old primer and start over Or can you apply correct primer over the old and then paint car?

Primer is a base coat that can accept all types of paint so no stripping is necessary and you can definitely primer over primer but remember to fill and sand before to eliminate blemishes and maintain a smooth finish.


Where is the primer pump on a 2002 cummins?

It doesn't have one. You have to cycle the key and let the electric pump run to fill with fuel.


What are the parts of a light bulb called?

The globe is the outer glass shell. The shaped coil inside is the filament. Wires and the stem support the filament inside the bulb. There are gases within the light bulb to prevent it from burning out. And the base is to securely support the bulb.


How do you start a weed eater?

Gas model? fill gas tank with proper mix of gas, [usualy 50 to 1 ] prime, turn on switch, crank it, More complete answer: I have an old pre-Poulan Weedeater brand string trimmer that requires the following steps: 1. Fill gas tank with 40:1 gas/oil mixture 2. Make sure switch is OFF and choke is on full 3. Pull starter 10-15 times (this primes the carburetor; other engines usually have a rubber primer bulb that needs to be pressed about 3 times) 4. Turn switch on and set choke at 1/2. 5. Pull starter to start engine. Let run 15-30 seconds before turning off choke


Why do you use argon in a light bulb?

Argon is used in a light bulb to fill the space inside the bulb and prevent the filament from evaporating. It also helps to extend the lifespan of the bulb by reducing the oxidation of the filament. Additionally, argon improves the efficiency and brightness of the light produced by the bulb.


Steps of measuring the medicine in the medicine dropper?

shake well, squeeze tip/bulb watch medicine fill tube, release bulb, notice med is at correct line, insert into proper orifice, squeeze bulb to discharge med. release bulb. remove.


How do you change headlights on 2001 Pontiac Sunfire?

make sure you fill up your headlight fluid after you change the bulb


How do you make a light bulb EXPLODE?

well you can get a hallow ball no holes attach a fuse fill the hallow ball with gun powder


Where do you find the oil drain plug on a weedeater lawn mower?

The cheap pos we bought from Walmart doesn't have a drain plug..must tip it on its side and drain it from the fill tube.