answersLogoWhite

0

Remove the electrical connector from the old resistor. Remove the screws holding the resistor in place. Remove the old resistor. Put in the new one and screw in the screws. Attach the electrical connector.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

93 Geo Metro you have a fan problem where the fan does not blow at full power and you do not know where to look for resitor packs or?

I have same problem. I put new blower and new resister, but did not solve the problem. The only part left to replace is the Fun control switch located on the dash. The blower resistor is locates on the blower case under the glove box. good luck.


Can you put a blower on a '89 Pontiac firebird?

you can put a blower on nearly any motor


What is a website where you can put a problem and get the step by step answer?

Step out


What word can be put in front of step?

The word "next" can be put in front of "step" to form the phrase "next step."


Where is the resistor located for the blower on a 2002 E250 4.2 v6?

look in the air duct close to the blower they put it there to cool it


Blower fan on 2006 kia sportage not working?

Check the fuse and relay first. Then check the blower resister, then the blower motor itself. One of these is probably the cause of the failure.


How do you replace a blower resistor on a 1998 Chevy cavalier?

This is a pretty simple fix. The GM part number for the Resistor is 52476725. Fits I believe 96-02 Chevrolet Cavaliers and Sunfire. Step 1: locate the blower motor under the dash on the passenger side. Step 2: To get to the resistor you need to remove the (3) screws holing up the blower. Remove the screws. The blower will come down. Remove the electrical connector, and slide the blower out of the way. Clear out any debris that may be in it. Step 3: The resistor is held up by (2) screws, (1) is easy to get to, the other is a bit tricky as you have to press back the rubber matting along the back firewall to get at it. Its a bit of a pain, but use a 1/2 in ratchet with an extension and you can get to it. Undo the screws, slide out the resistor. Pop it of, put the new one in. Step 4: Reverse the above and your done. Its about a 20 minute job if you don't know what your doing. Good Luck.


Can sea monkeys live with the million bubble blower?

i wouldn't put them in there if i were you


How to Change the blower motor 4Runner?

Leave the fan on and put a clutch under the fan,than if you have a turbo connect the fan blower to the turbo


Steps on how to manipulate the microscope?

Step 1: Put the specimens in the glass Step 2: Put it on the stage Step 3: Look at the eyepiece Step 4:You can manipulate the microsope!!!!


What facts and figures explain the Holocaust?

There are no facts or figures which can explain it. The Law of Gravity can explain why an apple falls to the ground, and the figure of 32 feet per second per second can explain how fast it will fall. * Step 1 is the apple is on the tree, held on by its stem * Step 2 is the ripening of the apple makes it too heavy for the stem to hold it. * Step 3 is the apple starts to fall * Step 4 is it picks up speed and hits the ground The electoral process in a country can explain how a government is elected. * Step 1 is an election is called * Step 2 is candidates put their names forward * Step 3 is the people vote * Step 4 is the party with the most elected candidates forms a government. These are things which follow logically upon the point at which one starts, but there was no logical process which can be pointed to so we could say that the Holocaust happened because step 1 happened and then step 2 happened and then step three happened, and so on. ___ Please see the Related Questions.


How does the box camera work step by step?

put a C4 in it