about 430ml of 10w (manual says 5w but everyone is using 10w, even shops recommends 10w)
The answer o your question is YES i have a 1996 zx7r that has a 2001 engine in it... All of the zx7r motors are exchangeable. You can actually place zx9r motor in a zx7r with few mods. About 2 hours of extra work an you will have a zx9 motor in an zx7r..
122 HP at 11,800 rpm.
There is a valve on the left side on top of transmission case.
No. Two completely different motorcycles. The ZX-7S is a "naked" sportbike.
theres a window about the size of a 2 pence piece behind the right fairing below the filler cap.
Most likely. Same thing happend to my ZX7R, if I have the starter button pushed in and hit the relay with the back of a screw driver I can get the bike to start.
Unless the battery is shorted or sulfated and will not take or hold a charge, most likely the alternator is bad
Yes, you can raise the suspension of a Kawasaki ZX-7R by adjusting the preload on the rear shock or by using aftermarket suspension components like longer shock absorbers or adjustable linkages. Additionally, you can modify the front suspension by using different fork internals or raising the forks in the triple clamps. However, any adjustments should be done carefully to maintain proper handling and geometry. It's advisable to consult with a suspension specialist for optimal results.
you can buy a real shop repair book on your bike from bike shop or on line, the same one the bike shop uses.its not cheap but tells everthing
they are located underneath the airbox filter assembly. first remove gas tank then you will see the airbox filter remove that and you should see them there waiting for you to give them a good cleaning....lol.hope that helps.
Electrode gap: 0.7 - 0.8 mm Spark plug: NGK CR9E For '94 - '04 Kawasaki ZX-7r Source: Haynes Service Manual hope this helps!
Take off the side fairings. on the bottom side of the engine there is a 17mm bolt, unscrew it counter clockwise (looking from the ground up). Catch the oil in a flat pan, (make sure there is enough to hold up to 4 liters. Wait for it to drain fully, in front of the engine on the left side is the oil filter, replace it with a new one. Put the bolt back in on the bottom. Fill oil as per normal with approx 3.5L of the oil of your choice. (consult manual)