answersLogoWhite

0

The fuel shut off switch is located on the trunk on the driver side. It is called a inertia switch. It is near the left hinge. The red switch should be in the up position for ON and pushed down for OFF. It can be reset by using a small screwdriver to push the switch up from underneath.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What would cause the headlight switch on an 1989 Mercury Grand Marquis to keep going out where as the headlights come on but the tail and dash lights don't and the fuse is good?

it's your headlight switch


Where is the Mercury switch on a 1989 Sundance?

A mercury switch is used for connecting current to a under-hood/hatch light.


What is the weight of a 1989 Mercury Grand Marquis?

5300lbs.


How can you start a 1989 mercury cougar with a broken ignition switch?

how can you start a '89 mercury cougar with a broken ignition switch?


1989 Mercury Grand Marquis computer location?

left side of dash


What is the gallon tank size on a 1989 Mercury Grand Marquis?

( 20 U.S. gallons )


Where is the back-up light switch located on a 1989 Mercury Topaz with an auto 4 cylinder?

On your 1989 MERCURY TOPAZ, the BACK-UP LIGHT SWITCH is: UNDER HOOD, DRIVER SIDE, LOWER ENGINE AREA, MOUNTED ON TOP OF TRANSMISSION


Where can you find a wiring diagram from the fuse box for 1989 Mercury Grand Marquis?

at the junk yard


Engine oil capacity 1989 Mercury Grand Marquis?

According to my Chilton's Auto Repair manual : For a 1989 Mercury Grand Marquis : With engine oil filter change : Both the 5.0 / 302 and the 5.8 / 351 take ( 5.0 U.S. quarts )


Can you get A diagram of PCV valve location in 1989 through 1999 Mercury Grand Marquis?

Yes, a person can get a diagram of the PCV valve location in a 1989-1999 Mercury Grand Marquis. This diagram would be located in the maintenance books found in auto part stores.


Where is the starter solenoid on the 1989 Mercury Grand Marquis?

its on the passenger side front near the front tire


Where is the mercury switch for the under hood lights on a 1989 corvette convertible?

The mercury switch for the under hood lights on a 1989 Corvette convertible is typically located on the hood itself, near the hinge or latch area. It activates the lights when the hood is opened, allowing the mercury inside the switch to complete the circuit. If you're having issues with the under hood lights, checking the switch for proper function or any damage is a good first step.

Trending Questions
How do you change the battery on 2006 dodge magnum? 1.5 volt batteries in series equals? How do you replace a differential rear pinion seal on a fd1lariat? Where is the crank position sensor located on a 1995 Nissan pick up 4-cylinder? Are there any apps like the ok google feature? Why would dexamethasone be prescribed in a course of fertility treatment? What sHow is the water pump is bad on a car? Where is the oil filter on a Peugeot 308 VTI 120? What would cause the scrapping sound near driver side front tire only it's not the brake itself and the tire is fine but car squeeks and makes metal to metal scrapping sound at low speeds or braking? What problems can a loose oil cap cause? Your key stays stuck in ignition cannot remove key you have a 2003 Toyota Camry any help? Can you sue the mechanic who installed an engine into your car in your garage and who failed to tighten the distributer properly causing the entire engine to seize? Could there be hidden damage from battery acid on carpet? Reconnected the battery and the car still not start? Where can you get a add on sleeper for my day cab truck? What vehicle uses PH4670? I have 06 streetbob hd and when it sits at an idle it has a noise come 'n from clucth area but then if i ingage the clutch leaver the noise stops kind of like a throw out bearing on a truck any help? What is the cross reference for a national 471224 seal? What is ignition trigger coil for? Should a timing chain on a 2006 Nissan Quest have to be replaced after 67000 miles?