answersLogoWhite

0

On vehicles equipped with a camshaft position sensor, it is used to help the PCM determine the correct firing order.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the IAT sensor on a 1991 Buick Park Avenue?

The 1991 Buick IAT sensor can be found in the air intake hose. The IAT sensor will be between the air box and the top of the engine.


Where is the camshaft position sensor located on a buick park avenue?

The camshaft position sensor on a Buick Park Avenue is typically located near the front of the engine, often near the camshaft or timing cover. In many models, it can be found on the cylinder head or engine block. Accessing it may require removing other components, so consulting the vehicle's service manual for specific details is advisable.


Where is the camshaft sensor on a 1989 park avenue?

On a 1989 Buick Park Avenue, the camshaft sensor is typically located near the front of the engine, often mounted on the engine block or cylinder head. However, it's important to note that the 1989 model may not have a camshaft position sensor, as this feature became more common in later models. Instead, it may rely on other sensors like the crankshaft position sensor for engine timing. Always consult the vehicle's service manual for the most accurate information.


What is the function of a pnp type sensor?

It allows your vehicle to start on when it is in park or neutral.


Where is the cam sensor located on a 1992 Buick Park Avenue 3.8L?

IS CALL CAMSHAFT SENSOR AND IS LOCATED ON THE RIGTH SIDE OF THE ENGINE , ABOVE THE CRANK PULLEY You will have a crank sensor, but it won't have a cam sensor. it dose have a cam sensor, on the timing cover left sind of water pump


Where is the crank sensor located on a 1991 Buick Park Avenue?

It's just behind the harmonic balancer.


What would cause a 1991 Buick Park Avenue not to start when the engine is cold?

check crank sensor


Is there a sensor in a 96 jeep grand Cherokee that unlocks doors when put in park?

A sensor, no. If that is a feature on a 1996, it is a function of the power door lock system.


Where is the camshaft sensor on a 1991 Buick Park Ave?

Camshaft Sensor is inside the engine near camshaft. I had it replaced a year ago. your looking at 300.00 + for job. Ask to have complete dino first to make sure of problem. The sensor itself mounts on the outside of the timing chain cover, just left of the hamonic balancer. Easy way to get at it is to remove the right wheel and the splash guards. I understand that it is usually not the sensor that fails, but the magnet that is attached to the cam gear under the cover. As the gear spins it triggers the sensor. The magnet is an $8 part, but you have to remove the timing cover to replace it. That's a $300 to $400 job. But first make sure the magnet's bad. You can use a mirror and flashlight to see it. If it looks ok, and still has good magnetic pull when you touch metal to it, it's probably OK. Autozone can test the sensor and see if it's working. It may simply be the wiring. Once you find the sensor, unplug the wires from it, inspect, and reconnect, then see if you get the same problem.


1991 Buick Park Ave just dies after a few minutes of running what is wrong?

check the MAF - Mass Air Flow Sensor


How do you check cranckshaft sensor on a 1991 buick park ave 3 8 V6 L?

I had an intermittent problem with that sensor on my PA. When the error code in the computer was checked, it showed up as a problem. I had it replaced. The cam sensor can cause a similar problem.


Can a camshaft on a 95 Buick park ave cause a car to stall out while driving?

No.