To replace the belt on an Indesit dryer, first, unplug the appliance for safety. Remove the back panel by unscrewing it, then take out the drum by removing any screws securing it in place. Once the drum is out, slide off the old belt and loop the new belt around the motor pulley and drum, ensuring it is properly aligned. Reassemble the dryer by reversing the disassembly steps and plug it back in to test.
The belt on a Maytag dryer is located around the drum, underneath the dryer’s top panel and around the motor pulley. To access it, you typically need to remove the front panel or the back panel of the dryer, depending on the model. The belt is responsible for turning the drum when the dryer is in operation. If the dryer is not spinning, checking the condition of the belt is a common troubleshooting step.
blue, thin belt, pink, take off belt, thick belt, blue, take off belt
dip ball in blue put | belt on dip in black take off | belt put - belt on dip in orange take off - belt put hat on dip in black take off hat put - belt on hat on dip in orange take both off put | belt on put hat on dip in blue take off both put - belt on and put the hat on to dip in orange take both off and there you go! :)
To perform a Maytag dryer belt replacement, first unplug the dryer and remove the front panel. Release the tension on the old belt and remove it from the drum and motor pulley. Install the new belt around the drum and motor pulley, ensuring it is aligned correctly. Reassemble the dryer and test it to ensure the belt is working properly.
you take off the right passanger tire....... take off the serpentine belt and the power steering belt....... then u take off the harmonic balancer with a three claw gear puller....... then take off the cover behind it....... take off the top cover to the cam gears........ put a jack under the engine....... take off the motor mounts...... then take off the timing belt tensioner..... then take off the belt....... then take of off the water pump......... easy as that
Generally speaking to take a drive belt off: 1. Loosen the adjuster bolt and the mounting bolt, loosen the belt. 2. Slip the belt off of the pulley. There may be as many as four belts. If the belt you are taking off is behind other belts you will have to take them off first. If that is the case make note of the routing of each belt as you take them off so you will know where to put them back.
take the back off and u will see where to put it.... Take off the front, remove the top retainers, lift the top up and then remove the remainder of the front panels, the blower assembly and then remove the drum....... rember where the screws go. Bqrry
dip ball in blue put | belt on dip in black take off | belt put - belt on dip in orange take off - belt put hat on dip in black take off hat put - belt on hat on dip in orange take both off put | belt on put hat on dip in blue take off both put - belt on and put the hat on to dip in orange take both off and there you go! :)
It depends on the dryer but it sounds like the belt might be slipping or one of the drum rollers rubbing. Unplug dryer and see if you can access it workings from the bottom, if not remove the back dryer panel. You can try some 'Belt Dressing Spray - Found in automotive shops" on the dryer belt or some WD-40 on the drum rollers should it be one of them. If all else fails replace the dryer belt but that can be a bit of a job and it could be cheaper to just buy a new dryer.
You probably either have too much weight in the dryer or something is off with the belt. Try putting in smaller loads to reduce the weight or if that doesn't work have someone come out and take a look at it.
Your dryer belt may be squeaking due to wear and tear or lack of lubrication. To fix it, you can try applying lubricant to the belt or replacing it with a new one.