There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.
Air filter is on the right side of engine compartment, toward the rear of the compartment. Remove the plastic cover by popping up the 4 plastic hold down buttons. Lift the cover off and you will see the air filter which is held in place by two spring steel tabs. Pull the tabs back and remove the filter. Replace the filter and the plastic cover.
It's an element-type filter (as opposed to cartridge type). On the front of the engine, just to the right of the inlet manifold, you'll see a black plastic circular cover, with a large "nut" on the top - this needs to be unscrewed, that's where you'll find the filter. Remove the old filter from the plastic lid, fit the new one, then screw the lid back on.
Remove the plastic cover underneath the engine u will find the oil filter.
There is a large plastic cover under the hood covering the engine. On right side it says "oil filter". Under that is the oil filter. You need to remove the 4 bolts holding on the plastic cover and then remove the cap to the oil filter (with an oil filter wrench). The oil filter is inside. The cap does not get replaced.
Purchase a Purolator Cabin Filter for your Impala. It comes with complete instructions. The filter is located below the windshield, passenger side. The black plastic cover must be removed to access the filter. You simply raise the hood and remove 3 plastic clips, and the washer hose from it's holders. This will allow you to remove the plastic cover over the filter.
The fuel filter is located on the top of the engine near the front of the engine. To access the filter you must remove the engine cover that says 7.3l powerstroke. That cover is fastened with two plastic nuts. To remove the filter you must remove the plastic filter cover which is circular and approximately 3 inches in diameter. That cover screws into the filter housing. Before changing the filter you should drain the housing which is done by opening the drain valve directly behind the filter housing.
Owners manual. remove glove box, cut plastic brace if this is the first time, remove metal brace, remove filter cover and pull out filter
This is for a Cabin Air filter. Open the glove box. Remove the plastic access cover from back of the glove box by releasing the tab and pulling the cover from the right side toward the seat. Then remove the filter cover by releasing the two (2) tabs, one on either side of the filter access cover. Then remove the filter by pulling the filter straight out and replace.
Open the locked door on tank, remove the plastic tray, remove the wing nut, slide the filter cover to the right, and tilt upwards , there is the filter.
The oil filter is underneath the xc90. First you have to remove the plastic cover, then you'll see the oilfilter cover on the passenger side of the car. The cover is a hard plastic black cap, that can only be removed with the right oilcap wrench.
The oil filter canister on your Vectra 2.0 CDI is under the top cover of the engine. It is on the right hand side.