0
What else can I help you with?
How do you replace a starter on a 85 cutlass?
The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.
How do I remove a dodge neon transmission?
The transmission on a Dodge Neon is removed by removing the axles, disconnecting the wiring harnesses, and unbolting it from the engine block. It can then be shifted away from the engine and lowered from the vehicle.
Before removing the radiator cap what must you ensure?
That the engine is cool.
When do you change the transmission on a 2006 Dodge Durango?
The transmission on a 2006 Dodge Durango is changed by removing the drive shaft, disconnecting the linkage, and unbolting it from the engine. It can then be lowered from the vehicle and replaced.
Turn off engine light Honda 2002 civic?
To turn off a 2002 Honda Civic engine light it needs to be reset. Resetting the light can be done by either disconnecting the battery or removing the ECU fuse.
Will disconnecting a battery cable cause a 2009 Chevrolet Cobalt's engine to stop running?
Yes, and disconnecting the battery while the engine is running can severely damage the computers
What is the process for performing a crank bearing replacement on a vehicle?
To perform a crank bearing replacement on a vehicle, the steps typically involve: Disconnecting the battery and draining the engine oil. Removing the engine from the vehicle and disassembling it to access the crankshaft. Removing the old crank bearings and inspecting the crankshaft for damage. Installing new crank bearings and reassembling the engine. Reinstalling the engine into the vehicle, refilling with oil, and testing for proper function.
How do you replace cambelt c3?
To replace the cambelt on a Citroën C3, first ensure you have the correct tools and a replacement belt. Begin by disconnecting the battery and removing any components obstructing access to the belt, such as the engine cover and pulleys. Align the timing marks on the camshaft and crankshaft to maintain proper timing, then remove the old cambelt from the pulleys. Install the new belt, ensuring it's correctly tensioned, and reassemble all components before reconnecting the battery and starting the engine to check for proper operation.
How do replace a water pump on a 2002 Hyundai accent?
The water pump on a 2002 Hyundai Accent is replaced by removing the engine accessories, disconnecting the radiator hoses, and unbolting the pump. A new gasket and pump can then be attached.
How do you change the water pump on a 1994 Chrysler concord?
The water pump on a 1994 Chrysler Concord is changed by removing the engine accessories, disconnecting the radiator hoses, and unbolting it from the engine block. The surface is then cleaned, a new gasket installed, and a replacement water pump mounted.
How do you steps on replacing intake manifold gasket on a 1998 Chevy venture?
extremely difficult without removing the engine. i have seen some drop the engine down about a foot by disconnecting the motor and transmission mounts & did not disconnect alot of lines and were able to change the intake gasket.
How do you reset the check engine light in a 1989 corvette?
You can reset the light by disconnecting the battery for 10 minutes. It will come back on again if you do not correct the problem that set the light in the first place.
