Send it to Midlands floor springs Limited who specialise in the repair of door closers and floor springs.
To add oil to an LCN 4041 door closer, first, ensure the door is in a closed position. Locate the oil fill screw on the closer body, usually found on the end or side. Using a suitable oil (such as hydraulic door closer fluid), insert a small amount through the screw hole, being careful not to overfill. Finally, replace the screw and test the door closer to ensure proper operation.
There's a star-shaped cap behind the battery (closer to the windshield) on the driver's side of the engine compartment. That's where the power steering fluid goes (I use dexron III automatic transmission fluid).
I believe the windshield washer fluid container in the engine compartment serves front and rear on 2002 and newer 4 door Explorers
You add the transmission fluid using the same tube that the transmission dip stick is in, use a long flexable funnel, and do not over fill.
It's on the driver side corner of the dash, open the door and you should find a small cover for it.
Add fluid the same place you check it. Caution: Do not overfill!Add fluid the same place you check it. Caution: Do not overfill!
The testes and the prostate add fluid to semen
You add it through the tranny dipstick hole, pull the dipstick out and add the fluid.
you can add a door stop, or put superglue :)
To add a door to a wall, you will need to measure and cut an opening in the wall that is the right size for the door. Then, install a door frame and hang the door on hinges. Finally, add a doorknob and any finishing touches.
You add fluid at the same place you check it.
where do you add the transmission fluid in a 1996 Honda accord 4 cylinderAnswerwhere do you add the transmission fluid in a 1996 Honda accord 4 cylinder