You will need a helper. Start at the Right Rear wheel and have the helper push down on the brake pedal and hold pressure then you will turn the bleed screw on the caliber counterclockwise. Once the brake pedal goes to the floor tighten the bleeder valve and then tell the helper to release the brake pedal. Keep repeating this until you see no more air bubble escaping from the caliber. Repeat these steps at the LR, the RF, and end up at the LF caliber. Make sure the helper keeps the master cylinder full at all times.
Use a turkey baster or something similar to empty the brake fluid reservoir as much as possible. Open the wheel bleeder valves and drain the lines. Refill the system, then bleed the lines on the Ford Focus.
how change brake fluid . i have ford focus lx 2000.ans how change air filter.
On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems
The kind in a can.
With an Easy-Out.
by unscrewing it.
To put brake fluid in a Ford Focus, you need to locate the master cylinder, which should be on the drivers side under the hood. On this , you'll find the brake fluid reservoir. You unscrew the cap and replenish using the right brake fluid, and screw the cap back on.
In North America ( DOT 3 brake fluid ) meeting Ford specification ( ESA-M6C25-A )
See answer on "How do you change the front brake pads on a 2001 Ford Focus?" for a description of the location of the resivoir. The answer to this exact location is at the bottom of that answer.
The brake fluid reservoir is mounted on the Master Cylinder. Drivers side near the firewall.
DOT ( 3 ) or DOT ( 4 ) brake fluid , according to the Owner Guide
Motorcraft High performance DOT 3 Motor Vehicle Brake Fluid.