try diss-conecting the battery for 15-30 minutes and hook it back up .
How do you reset the alarm for a Ford Laser
how to reset hornet alarm,, cause my car can't start..alarm still active,,
how do you reset alarm after rplacing the battery on 1999 toyota solara
Press reset?
no body knows
The easiest way to reset the your 2007 Mitsubishi Lancer car alarm is to remove the car alarm fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
You unlock t h e doors with the key to reset the alarm.
To reset the car alarm in a 1994 Jetta, start by unlocking the driver's door with the key. If the alarm is still active, insert the key into the ignition and turn it to the "On" position without starting the engine. This should deactivate the alarm. If the alarm persists, disconnect the battery for a few minutes to fully reset the system.
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
my alarm system keep disable my car how do I reset or disable this alarm system
use the consult-II with the NATS card to erase the codes. have your keys reprogrammed too.
To reset an anti-hijack car alarm, locate the alarm's reset button, usually found under the dashboard or near the ignition. Turn on the ignition without starting the engine, then press and hold the reset button for a few seconds until you hear a confirmation sound from the alarm. If your alarm system has a remote, you may also be able to reset it by pressing the designated button. Always refer to your vehicle's manual or the alarm system's instructions for specific steps.