answersLogoWhite

0

Connect a voltmeter across the battery terminals without engine running reading should be around 12.8

With engine running reading should be 13.8-14.2 if you are getting these numbers alternator is charging battery

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Is it necessary to replace a year-old battery when the alternator is replaced on a 1997 Pontiac Sunfire?

No way, only if the battery fails under a load test


How do you do a pressure test on a 1999 Sunfire?

Pressure test ?? Cooling system? A/C? Fuel Pressure? Compression?


How do you test fuel pressure on Pontiac sunfire 1999?

To test fuel pressure on a 1999 Pontiac Sunfire, you'll need a fuel pressure gauge. First, locate the fuel rail on the engine and find the Schrader valve, which is similar to a tire valve. Attach the gauge to the Schrader valve, then turn the ignition key to the "On" position without starting the engine to check the pressure reading. It should typically be around 41-47 psi; if it's outside this range, there may be issues with the fuel pump or fuel filter.


What kind or size of alternator for 1997 Pontiac Transport?

The 1997 Pontiac Transport has 2 different alternators . One is 105 amps and the second is 140 amps. It will depend on the power equipment you have on your vehicle. You may want to get an AVR test to make sure that it is the alternator before changing it. That test is about $30.00. Good luck


How do you adjust the clutch on a 1999 Pontiac sunfire 2.2 liter?

To adjust the clutch on a 1999 Pontiac Sunfire with a 2.2-liter engine, first, locate the clutch cable under the dashboard near the clutch pedal. Use a wrench to loosen the lock nut on the cable adjuster, then turn the adjuster to increase or decrease the cable tension until there’s about 1 to 1.5 inches of free play at the pedal. After adjusting, tighten the lock nut and ensure the clutch engages and disengages smoothly. Always test drive the vehicle to confirm proper clutch operation.


How do you check the fuel pressure on a 1996 Pontiac Sunfire?

If you pick up a Haynes or Chilton manual, you'll find all of the fuel system test procedures and requirements. FriPilot


Dodge avenger battery dead?

Charge it, replace it,test the alternator,Charge it, replace it,test the alternator,


How do you replace the turning signal flasher on a 2004 Pontiac sunfire?

To replace the turning signal flasher on a 2004 Pontiac Sunfire, first, locate the flasher unit, which is typically found under the dashboard near the steering column. Remove the old flasher by pulling it straight out of the socket. Insert the new flasher into the socket, ensuring it is securely in place. Finally, test the turn signals to confirm they are functioning properly.


How can you tell your alternator about to quit 1999 Grand marquis?

Test the volts out with a Volt Meter. Or take it to Advance Auto Parts. They will check it for free.


How do you replace a fuel filler door on a Pontiac sunfire?

To replace the fuel filler door on a Pontiac Sunfire, first, open the fuel filler door and remove any screws or clips securing it to the vehicle. Next, detach the door from the mounting bracket by gently pulling it away. Install the new fuel filler door by aligning it with the bracket, securing it with screws or clips, and finally, test the door to ensure it opens and closes properly.


How do you install license plate light 1995 pontiac sunfire?

To install a license plate light on a 1995 Pontiac Sunfire, first, locate the light assembly at the rear of the vehicle. Remove the screws or clips securing the light housing, then carefully pull it out. Replace the old bulb with a new one, ensuring it fits snugly, and reassemble the light housing by securing it back with screws or clips. Finally, test the light to ensure it functions properly.


How do test your alternator while in the car and the car will not start?

Car would either have to be running or alternator removed for bench test