0
What else can I help you with?
How do I reset my 2007 Chevy uplander?
To reset your 2007 Chevy Uplander, start by disconnecting the negative battery cable for about 15 minutes to reset the vehicle's electronic systems. After reconnecting the cable, turn the ignition to the "On" position without starting the engine and allow it to remain for a few moments. This may help reset the warning lights and other electronic features. If you're looking to reset the oil change light, turn the ignition to "On," press the gas pedal three times within five seconds, and the light should reset.
How do you get the battery light to turn off on a 1998 Chevy Malibu?
When this light stays on, it is telling you the system is not charging. Possible bad alternator, battery, or loose or disconnected wire.
05 Chevy Impala brake light come on when vehicle is turn off?
my 05 Chevy impala brake light come on when my vehicle is turned off killing my battery.
How do you reset the anti theft system on a 2005 Chevy uplander?
To reset the anti-theft system on a 2005 Chevy Uplander, first insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Afterward, turn the key to the "Off" position, wait a few seconds, and then start the engine. If the system persists in activating, you may need to consult the vehicle's manual or a professional mechanic.
How do you reset the monitor to turn off the low tire pressure warning in a 2003 Chevy impala?
disconnect your battery and then reconnect. The light should reset and turn off.
How do you turn off engine check light to Chevy cavalier after oxygen sensor is fixed?
Scan tool or unhook battery.Scan tool or unhook battery.
How do you turn off air bag light on 97 Chevy blazer?
my guess from what you said is that either the battery or alt. is getting weak battery and alternater replaced less than 4000 miles
How do you change a turn signal bulb on 2005 chevy uplander?
2005 Chevrolet Uplander turn signal light bulb lamp replacement procedure: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
What do you do to turn service airbag light off for a 2007 Chevy aveo?
remove the negative cable from the battery for 10 min. reconnect it.. if its not gone take it to a mechanic
How do you reset a dashboard security light on a Chevy truck?
If you want your service engine soon or check engine light reset than you can disconnect the battery. If you want the security light out you have to hook up a battery charger and turn your key to the on position without starting it. Wait at least 15 minutes, then turn key back to the off position and then try to start it.
How do I reset the check engine light on my chevy cavalier?
1. To reset the check engine light on your Chevy Cavalier, this is what you have to do. First, open the hood to the car, then turn the retaining nut on the battery’s negative cable clamps counterclockwise. Remove the cable clamp off the negative battery terminal by sliding it. Leave it unconnected for 5 minutes and then reconnect. Turn the ignition on and the check engine light will reset itself by blinking a few times and then shutting off.
Why No battery light on when ignition turn on?
bulb no good.
