remove ash-tray,remove two screws and gently pull on lower pannel. You now have access to a/c controls lights on rear of pannel. To remove top pannel just remove two screws at bottom of pannel and again gently pull pannel out.
If the VSS is defective replace the instrument cluster.
remove the complete dashboard and then replace it
Remove the instrument cluster then replace the bulbs. = =
instrument panel or controls?
You can't you have to replace the whole dashboard instrument cluster assy.
To change the interior and dash lights to blue in a 2006 Hyundai Tiburon, you'll need to replace the stock bulbs with blue LED bulbs. Start by carefully removing the dashboard panel and any surrounding trim to access the instrument cluster. Replace the existing bulbs with the new blue LED ones, ensuring they are compatible with your vehicle. Finally, reassemble the dashboard and test the lights to ensure they work properly.
Inside the instrument cluster. To replace them remove the cluster and take it apart.
You need to remove the instrument cluster.
To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.
To replace the dashboard lights on a 2002 Kia Spectra, first disconnect the car battery to ensure safety. Remove the dashboard trim and screws securing the instrument cluster, then gently pull the cluster out. Locate the burnt-out bulbs, twist them counterclockwise to remove, and replace them with new bulbs. Reassemble the dashboard by reversing the steps and reconnecting the battery.
To replace the blower motor on a 2001 Hyundai XG300, first disconnect the negative battery terminal. Then, remove the lower dashboard panel to access the blower motor, which is located behind the glove compartment. Disconnect the wiring harness and unscrew the motor from its housing. Finally, install the new blower motor, reattach the wiring, and replace the dashboard panel before reconnecting the battery.
You will need to remove the instrument cluster board. To do that, remove the trim piece around the instrument cluster, then carefully pull the instrument cluster out of the dashboard. Note that the instrument cluster plugs in to a socket in the dashboard, so be careful as you remove the circuit board so that you do not damage the plug. Once the instrument cluster is out, replace all bulbs. They twist to remove, and if the odometer bulb has failed, the others are getting old too. It might be best to replace them all to avoid future problems.