0
Best Answer
The brake fluid reservoir is usually located in the engine compartment next to the firewall close to the steering column. Remove the cover from the reservoir and fill to the proper level with your vehicle's recommended fluid type. If the brake pedal feels spongy or goes all the way down to the floorboard, you may need to bleed the brake lines.
Wiki User
∙ 17y agoThis answer is:
Add your answer:
Earn +20 ptsQ: How do you add brake fluid to a 2000 Dodge Stratus SE?
Write your answer...
Submit
Still have questions?
Related questions
How to change a fuse for brake light on 2000 dodge stratus?
You need to SWAP THEM!
Can brake pads from a 1997 Chevy cavalier be used on a 2000 dodge stratus?
NO
What is the correct transmission fluid for a 2000 Dodge Stratus?
Mopar ATF+4
What transmission fluid do I use for 2000 Dodge Stratus?
Mopar ATF+4
What kind of transmission fluid do you put in your 2000 dodge stratus?
Mopar ATF+4
How do you change the alternator on a 2000 dodge stratus?
bolt size on 2000 dodge stratus alternator
How do you replace the brake lights on a 2000 dodge stratus looked inside and do not see how you can get to the brake lights?
Often these are accessed thru the trunk; have you tried that?
How many motor mounts on a 2000 dodge stratus?
A 2000 Dodge Stratus has four engine mounts.
How do you time a 2000 dodge stratus with 2.4 motor?
2000 dodge stratus is electronicly timed you can not time it.
Why does power steerind not work in cold weather in 2000 dodge stratus?
loose belt or low fluid
What type of brake fluid does a 2000 dodge durango use?
dot3 or dot4
What would cause a hard brake pedal on a 2000 dodge stratus and this car does not have ABS?
this could be you're ABS sensor
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.