answersLogoWhite

0

There is a fill plug on the right side. Fill to the bottom of the hole

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How much gear oil does a muncie 4 speed hold?

8 pints


What type of fluid is used in a muncie 4 speed?

80-90wt gear oil GL-4


Muncie 4 speed?

automotive 4 speed manual transmission


How much oil does a muncie 4 speed hold?

There are several versions of the Muncie 4 Speed, Muncie M21 & M22 the SM465's and the SM420's. The SM465's for example were used in 1968-1991 General Motor Trucks Fluid Capacities should be in the 8.4 pints area from what I can find. Hope This Helps.


What type of grease do I use in a Muncie 4-speed?

80-90 wt GL-4 gear lube. It needs to be a GL4 rated oil, not GL5 rated.


What transmission is in a 1984 Pontiac fiero se?

4 speed manual Muncie Performance Transmission. The other 84's used the 4spd performance and 4 speed Economy trans. Made in Muncie Indiana.


What transmission came in a 1967 Chevelle?

Powerglide, Th350, Th400, or a muncie 4 speed.


What manual 4 speed manual transmission fits easily onto a 350 motor?

the tremec or muncie


How do you change the rear bearing in a Muncie 4 speed?

take bolts out the by a new one then put back on


Will a automatic driveshaft and a 4 speed interchange in a 1979 camaro?

No, the length will be different. mine came out of a 350 turbo went straight into a muncie 4 speed no problems


What is the spline count on a Muncie 4 speed?

The spline count on a Muncie 4-speed transmission's output shaft is typically 27 splines. This is common for the Muncie M20, M21, and M22 models. However, the input shaft can vary, with earlier versions having 10 splines and later versions having 26 splines. Always verify the specific model and year for precise details.


How do you check the fluid level in a muncie 4 speed transmission?

To check the fluid level in a Muncie 4-speed transmission, start by locating the fill plug on the side of the transmission case. Remove the fill plug using a wrench; the fluid level should be just below the fill hole. If fluid drips out when the plug is removed, the level is adequate. If not, add the appropriate type of transmission fluid until it reaches the desired level.