answersLogoWhite

0

With the brakes released and either the wheels chocked or the trailer brakes set, you rotate the nut on the slack adjuster until the brake shoes are tight against the drum. Then you back it off 1/4 to 1/2 turn. What tools you need specifically depend on which slack adjuster you have... you could have Bendix, Haldex,, or Wabco Meritor slack adjusters.

User Avatar

Wiki User

8y ago

What else can I help you with?

Related Questions

What is a bus slack adjuster?

slack adjuster is the adjuster on the brakes of vehicles with air brakes. these are used to adjust and take the slack out of the brakes caused by usual wear on the brakes


How does a slack adjuster work?

It have one way mechanism and it help to adjust it.


Where is the slack adjuster?

attached to the s cams in the brakes. to adjust the brakes.


Where is the slack adjuster located?

attached to the s cams in the brakes. to adjust the brakes.


How do you test a slack adjuster?

Assuming we are talking about "S" cam air brakes on a truck, check the angle at the end of the slack adjuster to the actuator rod coming out of the air brake can when brakes are applied, it should be 90 degrees, if the slack adjuster is manual adjust it with the brakes not applied and then test again. If they are automatic slack adjusters and you do not have 90 degrees with brakes applied it is worn out or not installed correctly.


What is an railcar slack adjuster?

I worked for a year and a half as a contractor Carmen on the bnsf. A slack adjuster is a threaed rod with adjusting nuts on the threaed portion that can adjust for proper tension on the brake rigging with includes rods and a chain and an air billow and brake shoes pressing up against the wheel.this slack adjuster must be properly adjusted for the brakes to work correctly.


How to adjust the clutch on a 99 escort?

where the clutch pedal is there is a long bolt this is the adjuster turn clockwise to take up slack


How do you adjust a clutch on a 1983 mercury capri rs 5.0?

it has an automatic adjuster on it. with the petal in the up position pull up on the petal and if the adjuster is working it will take the slack out of the cable. if not the adjuster needs to be replaced and this is not a fun job.


How much slack can you have in your slack adjuster to pass a dot inspection?

With the brakes applied, the angle of the slack adjuster and the actuating rod should be at 90 degrees.


How replace a slack adjuster on ken worth t660?

Remove the cotter pin and pin connecting the slack adjuster to the brake chamber, remove the locking ring on the inside which presses the slack adjuster to the s-cam, slide (or hammer) it out. Installation is opposite of reverse.


How adjust Volvo brakes with slack adjusters?

Volvos have automatic slack adjusters, which are dangerous to manually adjust. If your brakes are so far out of whack you think you might have to screw with the slack adjusters, you really need a brake job. Usually the slack adjuster must be backed off before you can remount the brake drums. The do have to be adjusted manually to get at least some drag on the drums before you set them automatically.


Where is the slack adjuster located on a school bus with air brakes?

An air brake system which uses foundation drum brakes will have one slack adjuster per brake - two per axle. They'll be located inside the wheel well - the slack adjuster is will be located at the end of the pushrod which extends out from the brake chamber.