answersLogoWhite

0

The following procedure applies to all small enginesIf the engine does not start:

(1) rotate the carburetor main jet needle valve clockwise (close) until it touches its stopping point - DO NOT FORCE OR GO BEYOND THE POINT OF TOUCHING as it may damage the tip.

(2) Rotate the needle valve counter-clockwise (open) 1-1/4 to 1-1/2 turns - this should be close enough to start the engine. Start the engine and let it warm up about five minutes.

(3) Rotate the needle valve clockwise (close) slowly until the engine starts to stall for lack of fuel, then rotate the needle valve counter-clockwise (open) slowly until the engine starts to stall from flooding (too much fuel).

(4) Set the needle valve to a midpoint between the two extremes for the best "purr" of the engine. If the engine "sputters" when a load is added, open the needle valve an extra 1/8 turn for a slightly richer mixture.

If the engine starts and you just want to adjust the carburetor, steps (1) and (2) are not necessary.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Who invented the tiller?

Mantis Tiller


8 HP troy built tiller gas pours out of carburetor?

Disassemble the carburetor and replace the needle and seat, following the manufacturers assembly and adjustment recommendations.


When was the Mantis Tiller invented?

1987


What's the most powerful electric roto tiller?

Mantis Electric Mini Tiller/Cultivator


What is the spark plug gap for mantis tiller?

0.024 - 0.028"


What are the most frequently requested spare parts for the Mantis Tiller?

The most frequently requested spare parts for the Mantis Tiller are Tine Pins, Spark Plug Spanners for the 4-Stroke Tiller, and Spark Plug Spanners for the 2-Stroke Tiller. Spark Plugs, Primer Pumps, Oil, and Fuel Filters for the 2 and 4-Stroke Tillers are also asked for a lot. Along with the items already listed, Air Filter Pads are frequently requested.


Is a Mantis tiller/cultivator good for home gardening only or can it be used professionally?

It is not heavy duty enough for most profesionals.


What is the mantis tiller flywheel to magneto gap?

The gap between the flywheel and the magneto on a Mantis tiller is typically around 0.010 to 0.012 inches (0.25 to 0.30 mm). This gap is crucial for ensuring proper ignition timing and preventing interference between the flywheel and the magneto. Always refer to the specific owner’s manual for your model for precise specifications and adjustments. Regular maintenance checks can help ensure optimal performance and longevity of the tiller.


What is the cost for a new garden tiller?

The price of a new garden tiller depends on the model and manufacturer. They may range in price from less than US$ 100 and up to almost $1000. Some common brands include Mantis, Honda and Husqvarna.


How do you change a belt on a front-tine tiller?

There is a problem of physics here. For every action there is a reaction. I assume you have a motor that turns a belt, that turns the tiller pully. If that tiller is rusted up for ten years or needs a mule to pull it - all bets are off. You have to look fer it.


Are there any good electric digging tools for small home gardens?

you could try a Mantis roto-tiller with its small footprint , it not a diigger but will loosen soil so you could remove easliy with shovel.


How do you say a tiller in spanish?

A small tiller