Make sure the master cylinder is kept full of fluid at all times and put your helper inside with foot on clutch petal, with the car jacked up and stands in place locate slave cylinder on drivers side and place a 11mm wrench on the bleed valve,. have the cockpit man push on the petal and hold it down, then open valve and let air and fluid escape being careful not to get fluid in eyes, tighten valve and tell helper to let petal return. its petal down-loosen-tighten-petal up. Repeat this process several times to remove air.
Bleed the clutch line that runs from the clutch master cylinder to the slave cylinder utilizing the bleed valve on the slave cylinder.
bleed clutch Saturn vue 2003
there dry clutch's, run a cable. no fluid. .:. you can't bleed it. :)
how do I bleed the clutch system in a 2004 ford ranger
after the clutch master cylinder has been replaced.
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...
same way you bleed the brakes. push clutch all the way to the floor and release the bleed valve on the transmission. tighten it up, release the clutch. Need 2 people to do it.
try to bleed the clutch
how to bleed the clutch system on ford f-250 2001 truck
Pinks - 2005 GTO vs- Model A was released on: USA: 13 July 2005