0
if you look at the bell housing you should be able to see the bleeder valve sticking out. take a socket and losen it is a 12 or 13 mm if i am not mistaken have some one else inside the car to pump the brakes watch fluid coming out when it stop sputtering and starts to flow smoothly tighten the bleed er valve back down. be sure to top off you fluid before you start
What else can I help you with?
Where is the Clutch safety switch 1994 firebird?
behind the clutch.....
How do you bleed the clutch on a 99 Saturn SL1?
bleed clutch Saturn vue 2003
What causes a 1995 Pontiac Firebird not to go into gear unless the car is off when the slave cylinder is full and a new clutch kit has been installed?
you have air in the lines bleed the slave
How do you bleed the clutch in a 95 Daewoo cielo?
there dry clutch's, run a cable. no fluid. .:. you can't bleed it. :)
Where is the clutch bleed line in a 98 Toyota 4-runner?
at the caliper and drums derrr! at the caliper and drums derrr! no its under the car where the clutch line goes into the trani at. they should be a 8mm nippple sticking out
How do you bleed the clutch line on a 2004 ford ranger edge?
how do I bleed the clutch system in a 2004 ford ranger
When do you bleed your clutch?
after the clutch master cylinder has been replaced.
How do you bleed a clutch on a Nissan stanza?
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
Where and how do you adjust the clutch on a 94 escort?
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
How do you bleed a hydraulic clutch system on a gmc sierra?
shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...
How do you bleed the clutch. 2003 Mitsubishi lancer?
same way you bleed the brakes. push clutch all the way to the floor and release the bleed valve on the transmission. tighten it up, release the clutch. Need 2 people to do it.
How do you get a hydraulic clutch on a 1986 C1500 working?
try to bleed the clutch
