How do you change Battery in Toyota key fob?

Answer 1

#1. Release Key by pressing down on the release panel on the side (it has a key insignia on the lever)

#2. Remove key by pulling chain with release panel open at the same time.

#3. Use flat pry tool (pocket knife) to separate sides of fob.

#4. Remove old battery.

#5 Replace with new battery (#1632) in 2007 Camry.

#6. Snap sides back together.

#7. Reinsert key.

#3. Rather than using a "flat pry tool," try the end of the key.

This answer is just flat-out wrong. The keyfob has a sliding cover, and if you try to pry apart the sides of the fob, you will break it.

Answer 2

To change the battery in a Toyota key fob, follow these steps:

Tools Needed

Small flathead screwdriver or a coin

Replacement battery (usually a CR2032)

Steps

Open the Key Fob:

Locate the seam where the two halves of the fob meet.

Use the flathead screwdriver or coin to carefully pry apart the fob.

Remove the Old Battery:

Note the orientation of the battery (which side is positive).

Take out the old battery and dispose of it properly.

Insert the New Battery:

Place the new battery in the same orientation as the old one (positive side facing up).

Reassemble the Key Fob:

Align the two halves of the fob and press them together until they click.

Test the Key Fob:

Press the buttons to ensure the new battery is working.

Tips

If the key fob doesn’t work after changing the battery, double-check the battery orientation and make sure the fob is fully assembled.

This should help you successfully change the battery in your Toyota key fob!