answersLogoWhite

0

Remove the small body panel by removing the three bolts from the wheel opening directly behind the front wheel, then take an open end wrench and loosen the bolt between the bottom of the small body panel and the molding it joins on the bottom. The wrench will barely go between the body panel and the bottom panel. If you look between them, you will see the bolt head. You only have to loosen this bolt, as it will not come out, then slide the body panel straight out to the side, remove the battery hold down clamp and slide the battery out.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you change a battery in a 1987 Corvette?

== ==


How do you change the battery on a 1989 Corvette Coupe?

== == == ==


Went out this morning to find your 1986 Corvette totally dead battery is fine what now?

1986 Corvette. Car drove fine a week ago. parked it in the garage and today totally dead. Where fron here?


When do change the timing belt on a 1986 corvette?

there is no timing belt it has a timing chain


How do you change the neutral safety switch in a 1986 corvette?

To change the neutral safety switch in a 1986 Corvette, first, disconnect the battery to ensure safety. Remove the transmission cover and locate the neutral safety switch, which is typically mounted on the transmission. Unscrew the old switch and disconnect the wiring harness, then install the new switch in the same position, reconnect the wiring, and reassemble the transmission cover. Finally, reconnect the battery and test the switch to ensure it functions properly.


Where is the mass air flow sensor burn-off-relay located on a 1986 corvette?

It is behind the battery on the firewall


What is the specific location for the fuel pump relay on a 1986 Corvette if there are three by the firewall two behind the battery and one on the firewall?

== ==


Is removing the battery in a 1993 Corvette the same as removing the battery in a 1995 Corvette?

yes


How do you remove a starter on your 1986 Corvette?

To remove the starter from a 1986 Corvette, first disconnect the negative battery cable to ensure safety. Then, lift the vehicle and support it on jack stands. Remove the starter mounting bolts and disconnect the electrical connections, including the battery and solenoid wires. Finally, carefully pull the starter out from its position and set it aside.


What is the fuel tank capacity of a 1986 Corvette?

1986 corvette fuel tank capacity is 20 gallons.


Can 1991 Corvette door panels go in a 1986 Corvette?

no


What could be pulling the battery down in 1981 Corvette?

what could be pulling the battery down in a 1981 corvette