Trailblazer enthusiasts will cover all the subjects including brake jobs at www.trailvoy.com
The ABS module on a 2002 Chevy Trailblazer is typically located on the driver's side, near the firewall, just behind the engine. It is mounted on the brake master cylinder and is connected to the brake lines. To access it, you may need to remove some components or covers in the engine bay.
All vehicles have brake pads.mine has disk brakes and the pads take about 10 minutes a piece to change.
As far as I know, they are not on the same fuse/relay.
size of bolt on break calliber on Chevy trailblazer
The ABS module on a 2004 Chevy Trailblazer is typically located under the hood, mounted on or near the brake master cylinder. It is part of the hydraulic control unit and can be found on the driver’s side of the engine compartment. To access it, you may need to remove some components for better visibility. Always consult the vehicle's service manual for precise location details and safety precautions.
Yes.
The ABS and parking brake lights on a 2002 Chevy Trailblazer may stay on due to a malfunction in the ABS system, such as a faulty wheel speed sensor, or issues with the brake fluid level or the parking brake itself. If the parking brake is not fully released, it can trigger the light as well. Additionally, a problem with the ABS module or wiring could also cause these warning lights to remain illuminated. It's advisable to have the vehicle diagnosed using an OBD-II scanner for accurate troubleshooting.
The brake rotors are warped are out of round. Need to do a brake job and have the rotors turned are replaced. Be sure to install new pads and shoes.
You have to open the rear hatch like you would to replace the reg. brake lights. Screws should be accessible once hatch is fully open.
in the engine
Probably a faulty ignition switch. learn more at www.trailvoy.com Trailblazer enthusiasts website.