To change a cigar lighter in a vehicle, first, ensure the ignition is turned off and the vehicle is in park. Use a flathead screwdriver to carefully pry out the old lighter from its socket. Disconnect the wiring by unscrewing or unclipping it, then connect the new lighter by reversing the process. Finally, push the new lighter into the socket until it clicks into place.
To change the cigar lighter fuse in a 2002 Jeep Cherokee, first locate the fuse box, which is typically found under the dashboard on the driver's side. Use a fuse puller or pliers to remove the fuse associated with the cigar lighter; it is usually labeled in the fuse box diagram. Replace it with a new fuse of the same amperage, ensuring it is seated properly. Finally, test the cigar lighter to confirm it is working.
To change the cigar lighter fuse in a Jaguar XKR, first, locate the fuse box, which is typically found under the dashboard on the driver's side or in the engine compartment. Use the fuse diagram on the cover to identify the specific fuse for the cigar lighter. Carefully pull out the blown fuse using fuse pullers or pliers, and replace it with a new fuse of the same amperage. Finally, recheck the cigar lighter to ensure it is functioning properly.
See layout diagrams here: http://www.fordmondeo.org/wiki/images/8/89/Glovebox_relays.jpg The cigar lighter is F68 at the top of the far left column
( Fuse number 27 ) is a 15 amp fuse for the cigar lighter
To change the cigar lighter in a 1989 Mazda B2200, first, disconnect the negative battery terminal to ensure safety. Remove the center console or trim panel that houses the lighter by unscrewing it or gently prying it off. Once exposed, disconnect the wiring harness from the old lighter and remove it from its socket. Install the new lighter by reversing the process, reconnecting the wiring, and reassembling the console.
( # 41 ) - 20 amp mini-fuse - cigar lighter , diagnostic connector power
You can replace the cigar lighter in a 99 Grand Am by removing the fuse and then removing the lighter element. You will then need to remove the lighter socket and disconnect the electrical connections. The last step is to reverse these instructions to put in the new lighter.
15 amp fuse under hood, labeled in diagram as "CIGAR"
In a 2005 Land Rover, the fuse for the cigar lighter is typically located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove a cover panel. The specific fuse for the cigar lighter is usually labeled in the fuse diagram found on the cover or in the owner's manual. If the cigar lighter is not functioning, check this fuse and replace it if necessary.
a good quality lighter
fuse # 24 is a 15 amp fuse for your cigar lighter , OBD II , neutral tow
push the lighter in, and when it pops out remove it. and remember IT WILL BE HOT!