jack up entire front end, remove front wheels. break axle nut loose. its on with 180-220 ft lbs torque. remove ball joint from hub OR remove two bolts from strut to hub monting. remove brake line and abs wire from strut [clips] push axle out of hub, and use prybar to pop out of transmission. make sure circlip came out of transmission on axle. push inner joint into transmission, make sure circlip locks into tranny. you should NOT be able to pull axle out with your hands. the PASSENGER side is a PITA. there is a center bearing that creates equal length halfshafts. remove three bolts, and pry axle from carrier, OR unbolt carrier from engine and pry off axle on bench. axle bolts- 180-220 ft lbs. strut bolts - 90-110 ft lbs. ball joints- 40-60 ft lbs.
The 3.0 litre V6 engine in a 1999 Infiniti I30 has a timing CHAIN
You don't.
Where is the knock sensor in a 1999 Infinity I30?
http://forums.maxima.org/infiniti-i30-i35/589286-how-remove-fog-lights-96-99-i30.html
i know what the part looks like but i cannot locate it on the engine.
how to change the thermostat on a 99 infinity I30
The 3.0 litre V6 engine in a 1999 Infiniti I30 has a timing CHAIN
6 1/2 inches
i30 was last made in 2001. never need to service any infiniti timing chain, only if it has a belt
How much it did odometer infiniti i30 2000
under the vehicle, close to the oil pan.
were is the egr valve located on a 1998 infiniti i30