0
I wasn't aware they still came with drum brakes... I've owned three and they've all been 4-wheel disc. If drums were still an option, it will take replacing all factory parts which are different from drums to discs and could be very expensive. This may include the wheel speed sensors and possibly the ABS unit itself. It doesn't sound worth the effort.
What else can I help you with?
How do you change brakes for a 1983 Monte Carlo?
Remove the tire and wheel. Remove the brake pad springs and hardware. Remove the brake rotor. Reverse the process to install the new brake and rotor.
Where is a 1999 Monte Carlo 3.1 distributor and rotor?
It doesn't have a distributor or rotor. It has a DIS (Distributorless Ignition System).
What will cause a 1987 Monte Carlo not start it has a weak fire?
I would try distibutor cap and rotor.
What size torx socket to remove front rotor on 2004 Monte Carlo?
To remove the front rotor on a 2004 Monte Carlo, you typically need a T30 Torx socket. Make sure to check for any additional fasteners or components that may need to be removed to access the rotor properly. Always refer to the vehicle's service manual for specific details and torque specifications.
How do you change rotors 1995 Monte Carlo?
remove the calipers, and caliper bracket on the back side of the spindle I believe it take a T-65 torx. rotor should just slide right off.
Fix pulsating brakes on ford expedition 2004?
Change your brake rotor and brakes. problem solve
How do you change rotor on 1987 Monte Carlo?
You didn't specify brake rotor or ignition rotor. If it's the brake rotor, remove the front wheel, remove the brake caliper, remove the bearing dust cap, remove the cotter pin, and then remove the castle nut, this will free up the rotor to be removed from the spindle. While it's off you may as well replace the wheel bearings. If its the ignotion rotor you simply remove the distributor cap, and then two screws hold the rotor on.
How to fix Pulsing front disc brakes?
you have to change the rotor cuz the rotors slightly bent or its groover to bad and when u change the rotor change the pads as well on both sides
How do you change the brakes and rotors on a 1993 Chevy Lumina?
Remove the tire and wheel from your 1993 Chevy Lumina. Remove the brake assembly spring and the brake caliper. The brake assembly will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to change the new rotor and brakes.
How do you do a tune up on a 83 Monte Carlo ss?
replace the spark plugs, plug wires, distributor cap and rotor, set the timing, replace the air filter and fuel filter.
How do you change rear rotors on a Nissan Murano?
The Murrano has two set of brakes on the rear, it has the internal one witch is your E brakes and then it has the regular caliper brakes. How to change the rear brake rotor? Well after you taken the calipers of you need to make sure you don't have your E-brake one. ( please make sure that if working on a drive way you shock the front tire) this will prevent the car from rolling. To change the rear rotor you have to hit the center of the rotor with a hammer. The rotor will pop out and then simply pull out and install the new one. NOTE: inspect the rear E-brake while you have the rotor out.
Why are my brakes rubbing on the rotor?
Your brakes may be rubbing on the rotor due to issues such as misalignment, worn brake pads, or a warped rotor. It is important to have your brakes inspected and repaired by a professional to ensure safe driving conditions.
