answersLogoWhite

0

To change the rear brake rotors on a 2006 GMC 3500 dually, start by safely lifting the vehicle and removing the rear wheels. Disconnect the caliper by unbolting it and suspend it without straining the brake line. Remove the old rotor by unscrewing any retaining screws and sliding it off the hub. Install the new rotor, reattach the caliper, and ensure everything is secure before replacing the wheels and lowering the vehicle.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

How do you change rotors on a 2006 Dodge Dakota?

remove wheelremove brake caliperremove rotor


How do you replace front brake rotors on 2006 Chevrolet aveo?

See below article-


How much is brake replacement on a 2006 dodge charger?

$360 @ Graham Tire for rear brakes and rotors


How much to replace front brake pad and rotors on a 2006 Toyota Corolla?

Depending on the pads, around $150 for front or rear, and depending on the car, around $250 for the rotors.


2006 Honda Accord ex rear brake pads how to change?

How do you change rear brake pads on a 2006 honda accord ex?


What is wrong with my 2006 KIA i was travelling along the motorway at about 70ish the car started droning then you put the breaks on and the whole car was shuddering?

It could be an out of balance wheel or warped brake rotors. My car use to shudder when the brakes were applied and it was warped brake rotors.


What is the minimum thickness of brake rotor for 2006 Buick lacrosse?

The minimum thickness for the brake rotors on a 2006 Buick LaCrosse is typically 1.00 inches (25.4 mm) for the front rotors and 0.87 inches (22 mm) for the rear rotors. It's essential to check the specific manufacturer's specifications or the owner's manual for any variations or updates. Always ensure that rotors are measured accurately and replaced if they fall below the minimum thickness to maintain safe braking performance.


How often do you need to change brake pads or rotors on a 2006 Jeep Liberty?

Brake pads on a 2006 Jeep Liberty typically need to be replaced every 30,000 to 70,000 miles, depending on driving habits and conditions. Rotors may last longer, often around 70,000 to 100,000 miles, but should be inspected for wear and warping each time the pads are changed. It's important to listen for squeaking or grinding noises, which can indicate that the pads need attention. Regular maintenance checks are crucial for optimal brake performance.


How do you change the front and rear brake rotors on a 2006 Mazda 5?

If they are of the "peel off" type Remove wheels Remove caliper mounting bolts Slide calipers off rotor Slide rotor off hub


How do you change the rotors on 2006 Kia Sorento?

There pretty standard, nothing special about them. A hand impact makes getting the two screws out of the rear rotors easy.


How do you remove front brake rotors on a 2006 Chevy 1500 silverado?

Tap off the rotor, it should come off, if not, I can't help you.


How do you change rotors on 2006 Lincoln mark lt?

To change the rotors on a 2006 Lincoln Mark LT, start by safely lifting and securing the vehicle on jack stands and removing the wheel. Next, remove the brake caliper by unbolting it and hanging it out of the way, then take off the caliper bracket if necessary. Remove the old rotor, clean the hub surface, and install the new rotor. Finally, reassemble by reinstalling the caliper and wheel, then lower the vehicle and test the brakes.