First off you'll need a strut compressing tool because I don't think the struts are sold with the spring. It's quite a job. Easier with air tools, but can be done with hand tools. Jack up the rear of your car, remove tire, remove bolts from the trunk area (there should be 2 or 3). There's a bolt on the bottom of the strut that needs to be removed. Then the whole assembly should come out. You may need an extra jack to support the rotor(put a piece of wood on jack so you won't accidentally damage the rotor) when you remove the strut assembly. Then use compression tool to squeeze the big spring. If you go to auto parts store, they can also print instructions that will be more in depth from what I'm typing here. That may be more helpful for you. Good luck. I'd have a buddy helping too. lol.
how do i reset the computer on my hyundai xg300
The heater blower in a 2001 Hyundai XG300 is located on the passenger side of the engine. The blower resistor will be located on the firewall.
its located under car by rear driver side wheel
in the fuel tank
You've seen this, right? http://mlittle.com/Hyundai/remote/
TCS stands for Traction Control System.
A fuel pump relay switch is an electric switch which activates the fuel pump when the engine is cranked and when the engine is running. The switch is located under the dashboard near the steering column on the 2001 Hyundai xg300.
A fuel pump relay switch is an electric switch which activates the fuel pump when the engine is cranked and when the engine is running. The switch is located under the dashboard near the steering column on the 2001 Hyundai xg300.
go to the Hyudai dealer and pay large
The starter on a 2001 Hyundai XG300 is located on the lower side of the engine, near the transmission. To change it, first disconnect the negative battery cable, then remove any components obstructing access to the starter, such as the air intake duct. Unbolt the starter from its mount, disconnect the electrical connections, and replace it with the new starter. Finally, reassemble everything in reverse order and reconnect the battery.
2 struts for the front and 2 regular shocks for the rear.
To change the headlight on a 2001 Hyundai XG300, first, open the hood and locate the headlight assembly. Disconnect the power connector from the back of the headlight bulb and remove the retaining clip or twist the bulb counterclockwise to release it. Replace it with a new bulb, making sure not to touch the glass with your fingers, and then reattach the connector and secure the assembly back in place. Close the hood and test the new headlight to ensure it's working properly.