how 2 change a 1999 speedo cable
In a 1996 Ford Festiva, the speedo cable is typically located in the engine compartment, connecting the transmission to the speedometer in the dashboard. You can trace it from the transmission, where it screws into the speedometer drive, up to the back of the speedometer gauge. If you're having difficulties locating it, consulting the vehicle's repair manual can provide specific diagrams and details.
To replace the speedometer in your 1988 Ford Festiva, start by disconnecting the negative battery terminal to ensure safety. Remove the dashboard trim and the screws securing the instrument cluster to access the speedometer. Carefully disconnect the speedometer cable and the electrical connectors, then remove the old speedometer and install the new one by reversing the process. Finally, reassemble the dashboard, reconnect the battery, and test the new speedometer for proper functionality.
Speedometers are not cable driven anymore, they are electronic. You may have a faulty speed sensor.
You need to remove the speedometer sending unit from the transmission - this hole is the hole you put new fluid in. Trace where the speedometer cable (mechanical cable, not electrical) is going, it starts on the firewall behind the dash cluster.
Yes , I BELIEVE the last year for a speedometer cable on a Ford Explorer was the 1995 model year so the 1991 Ford Ranger would definitely have a speedometer cable
The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
As far as I know the 1995 Ford Explorer is the last model year to have a conventional speedometer cable ( so yes )
I believe that 1995 was the last year for a conventional speedometer cable on a Ford Explorer , and then Ford went to an electronic speedometer with a vehicle speed sensor
The speedometer sensor is in the top of your rearend housing.
To remove the speedometer gear drive assembly on a 1993 Ford Festiva, first, ensure the vehicle is on a level surface and disconnect the battery. Then, locate the speedometer cable connecting to the transmission; unscrew and remove it. Next, remove any retaining clips or screws securing the gear drive assembly, and carefully pull the assembly out from the transmission. Be sure to replace any worn seals or O-rings during reinstallation to prevent leaks.
I don't believe it has one , the Ford Explorers 1996 and newer models don't have a conventional speedometer cable , they have an electronic speedometer and a vehicle speed sensor ( VSS )