Pop the hood. Disconnect the negative battery cable, then the positive battery cable. If you disconnect the positive first you could possibly ground out the battery with your wrench causing a short. Once those have been disconnected the car should have no power. There is a battery tie down on top of the battery that holds it in place. On one side of the battery tie down there is a bolt threaded on to a long rod that continues down to the bottom of the battery. I believe that bolt is either an 8mm or 10mm. Once that bolt has been removed the battery tie down bar can be removed and there is a black plastic box that sits around the battery and that should lift right up. Once those pieces have been removed the battery is free to be removed. Follow the same steps in reverse to install a new battery. The main thing is that when putting the cables onto the new battery put the positive on first then the negative.
Yes they will fit. There is not a difference in part number for a protege or protege5.
Where is the igniyion coil on a2002 mazda protege
To change the overdrive switch on a 2002 Mazda Protege 5, first, disconnect the negative battery terminal to ensure safety. Then, remove the gear selector cover by unscrewing it and carefully pulling it off. Locate the overdrive switch, disconnect the wiring harness, and replace the old switch with a new one. Finally, reassemble the cover and reconnect the battery terminal.
Mazda recommends that the belt be replaced every 105k.
how do u replace alternator belt on 2002 mazda protege 5 stationwagon
in your face :)
no it will not fit.it is not the same lenght and the same height
The pulse generator on a 2002 Mazda Protege is located on the top of the transmission. The pulse generator can be purchased at any auto parts store such as NAPA.
For a 2002 Mazda Protege 5, the recommended oil is a 10w 30. 5w30 is recommended in temps below 30 degrees f.
does a 2002 mazda protege have a front wheel drive
I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.
To change a fuel line on a 2002 Mazda Protege, first ensure the vehicle is off and the fuel system is depressurized. Disconnect the negative battery terminal, then locate the fuel line and use appropriate tools to remove any clamps or fittings. Replace the old line with a new one, ensuring all connections are secure and leak-free, and finally reconnect the battery and test for leaks before starting the engine. Always refer to the vehicle's service manual for specific instructions and safety precautions.