You will need a floor jack to support the engine and a jack stand, along with the tools to take loose the alternator, compressor and adjustor for the main belt. You will need to take off the passenger side front wheel, and take loose the engine mount )support the engine with the floor jack before taking loose the engine mount on the fender. Only loosen and take loose the mount from the engine side. This needs to be pulled out of the way along with the tire in order to have access to the belts. start at the outer most belt and work in to remove the belts, then do the reverse for the install.
There are four belts. 1. Power steering 2. Alternator 3. A/C 4. Timing belt
no it won't the 2000 has diffrent plugs by the dip stick its a six pin . i made that mistake and got a 99 at trans for my 2000 and notice its the same in a accent 97-99 and the elantra but change in 2000 hope this helps
1997-2000 Hyundai tiburon, 1997-2000 elantra.
find the location of a 2000 hyundia elantra starter
no, different designs.
The engine oil capacitie with oil filter change is 4.5 QTS
Its should be same thing
The spark plug gap for a 2000 Hyundai Elantra should be set at .044 inches. New spark plugs will be preset at the factory.
The starter on a 2000 Hyundai Elantra is located along the bottom, left side of the engine. It bolts directly to the engine block and is protected by a shroud.
Is the fuel pressure regulator 2000 elantra near gas tank? thanks
195 60 r14
4 X 100.0mm