Step one is to remove the tire. Step two is to remove the brake caliper. Step three is to remove the cap that covers the spindle the rotor is spinning on. Step four is removing the bolt holding the rotor on the spindle. Step five is pulling the rotor off the spindle.
There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
No, the front. A Chrysler Sebring is front wheel drive.
Bank two is the front head on a 2001 Chrysler Sebring.
Yes , the 2001 Chrysler Sebring is front wheel drive
Yes
In front of the left front tire.
Yes
The Chrysler Sebring drive belt can be found on the front of the engine. It is also referred to as a serpentine belt. The timing belt can be found behind the front engine cover.
when you remove the caliper on the disk brake by removing the bolts on the inside of the caliper the rotor just slides off, the only thing holding the rotor in place is the wheel.
This change out should be fairly easy (compared to the front rotors). I changed out the rear rotor on a 2000 Sebring Convertible rather quickly. Buy the rotor at Autozone or o'Rielly and you will see that it justs slips over the lug nuts. The old one may take a little tapping around the edges to loosen it up. Use a gear puller in a worst case scenario. RB in Houston
It is in front of the radiator.
Yes.