0
There are two screws under the back dash that need to be removed to lift the assembly off the back dash. I had a problem with the same car. No brake lights at all. I disconnected the power to the third light and the main two brake lights started to work. There must be a short in the third brake light harness.
What else can I help you with?
How do you change a horn on 2008 Kia optima lx?
i have a 2008 kia optima and the horn is about to go out how do i change it. for a little od nothing.?
Why are my 2008 Kia Optima brake lights not working?
he first thing to check is the 15amp fuse located in the cabin fuse panel. If that is ok then you will more than likely have to change the brake light switch. It is located at the very top of the brake pedal assembly. If it ends up being the bulbs, see sources and related links below for bulb info.
How do you i change 2008 Ford Focus brake light?
To change the brake light on a 2008 Ford Focus, start by opening the trunk and removing the plastic cover or panel that protects the rear light assembly. Next, locate the brake light bulb socket, twist it counterclockwise to remove it, and then pull out the old bulb. Insert the new bulb into the socket, reassemble the components, and test the brake light to ensure it's working properly.
What fuse do you change on a 2008 Hyundai elantra if the rear brake lights and third rear brake lights do not work?
it would be the brake light switch about 20 dollars at autozone
How many valves does the 2008 Kia Optima have?
The 2008 Kia Optima has 16 valves.
Where is the brake light switch in a 2008 freightliner M2?
Attached to the brake pedal.
Is the 2008 Kia Optima electric or gas?
The 2008 Kia Optima is a gas-powered vehicle.
What kind of transmission does the 2008 Kia Optima have?
The 2008 Kia Optima has a 5-speed manual.
What size engine does the 2008 Kia Optima have?
The 2008 Kia Optima has an inline 4 engine.
How do you change brake light bulbs on a vw polo 1.2 2008?
To change the brake light bulbs on a 2008 VW Polo 1.2, first, open the boot and locate the tail light assembly on the side where the bulb needs replacement. Remove the access cover or screws to detach the tail light assembly. Once exposed, twist the bulb holder counterclockwise to release it, replace the old bulb with a new one, and reassemble the light by reversing the steps. Finally, test the brake light to ensure it’s working correctly.
What is the curb weight of the 2008 Kia Optima?
The curb weight of the 2008 Kia Optima is 3142 lbs..
What kind of fuel does the 2008 Kia Optima use?
The 2008 Kia Optima runs on regular unleaded.
