answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the temperature sender located for the temperature gauge on a 1990 Chevy lumina?

1990 Chevrolet Lumina temperature sender is located on the back side of the thermostat housing. The sender has a wire that goes to the temperature gauge.


How do you change a turn signal on a 1991 Chevy Lumina?

how can i change the turn singal on a 1990 Chevy lumina


How do you test the fuel pump on a 1990 Chevy Lumina Euro?

Hook a fuel pressure gauge to the fuel pressure rial and just turn the key on and see if you get any pressure reading. If not you may have a bad relay, or a blocked fuel filter or the pump is bad itself.


What make a 1990 Chevy Lumina Car cutoff?

what make a 1990 Chevy. Lumina Car cut off when make a complete stop.


How do you unlock a 1990 Chevy Lumina?

with a key


What year did Chevy Lumina come out?

1990


Why does your 1990 Chevrolet Lumina not wanting to start when you try to start it it only runs for like a little second then cuts off you have could it be the fuel pressure regulator the coils have b?

The fuel pressure regulator or the fuel pump could be bad on the 19900 Lumina. Check both of these to start troubleshooting the problem.


Is there a fuel reset button on a 1990 Chevy Lumina?

No.


Where is the Fuel Pump located on a 1990 Chevrolet Lumina Euro?

If its like the 1993 Lumina it's in the fuel tank.


What is wrong if your 1990 Chevy Lumina won't crank?

well the question is a bit vague but I'll try. Assuming that the battery isn't dead and the starter is cranking fine my first thought would be your fuel pump is shot Chevy fuel pumps are notorious for failure even with low miles I had to replace my brothers fuel pump on his 96 Chevy and it only had 58,000 miles on it. But to know for sure wether the pump is bad or not you will have to do a fuel pressure test. You can test the fuel pressure by getting a fuel pressure gauge and attaching it to the test port on the fuel rail and watching the gauge as somebody tries to crank it over if the gauge reads beetween 40 and 60 PSI then the pump is good if not then replace the pump most likely if pump is bad you will get a reading of 0 to 5 PSI. Hopefully this helps.


1990 Chevy Lumina APV starts fine but quickly stalls?

Check the fuel filter. If it is the original, change it. If that doesn't help, find a mechanic.


Where is the oil pressure gauge located on a 1990 Dodge Dynasty?

On a 1990 Dodge Dynasty, the oil pressure gauge is typically located on the instrument cluster, which is situated on the dashboard in front of the driver. It may share space with other gauges, such as the speedometer and fuel gauge. If you are looking for the oil pressure sending unit, it can usually be found on the engine block, near the oil filter. Always refer to the vehicle’s service manual for precise locations and specifications.