answersLogoWhite

0

i need to know what wires need to be disconnected to change tail light assembly on a 92 saturn sl

See sources and related links below for bulb information.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change the rear tail lights on a 1995 Saturn SL Can you just change the individual light bulbs or do you have to replace the whole assembly?

From inside the trunk, pull away the felt trunk liner to expose the tail light assembly. Turn the socket COUNTER-CLOCKWISE to pop it out of the tail light assembly.


What if your 97 Saturn sl-1 dash lights wont come on but the headlights do?

In that case, you probably don't have tail lights or clearance lights either.Check the fuses. If that's not it, you may have a faulty light switch.


How do you change thermostat on Saturn Sl?

heck the link below


How do you change transmission on Saturn sl?

take it to a mechanic n have them do it


How do you change crankshaft sensor in a 2001 Saturn sl?

were is crankshaft sensor located in 2001 Saturn l300


What would make the reverse lights not work on your 1995 Saturn sl?

Bad bulbs? Blown fuse? Bad switch?


How do you fix parking light of Saturn sl 2?

open ur trunk and there are 6 bolts you have to take off to get to the lights


How many quarts of oil do you put into the 2001 Saturn sl-1 for an oil change?

4.5qts


How do you change a clutch on a 94 Saturn sl?

go to the library and copy the instructions from a repair manual


How much does it cost to repair a clutch on a 1999 Saturn sl?

The average cost of repairing a clutch on a 1999 Saturn SL is anywhere between $400 to $3000. The Saturn SL was produced from 1990 to 2002.


How many quarts of oil for an oil change for a 1995 Saturn sl?

Start with 4qts, but be prepared for it to take 4.25.


After changing the driver side brake lights on a 93 Saturn Sl both tail lights not coming on when the headlights are turned on also the inside dash light only comes on when the brakes are applied?

it sounds like your wires have been reversed, check your light assembly against the other side that you did not change and make sure they match. You more than likely have a ground problem. These type problems are very difficult to find. Good luck.