The APP sensor is located on the right side of the upper end of the accelerator pedal * Disconnect the negative battery cable * Remove the knee bolster * Disconnect the electrical connector from the APP sensor * Remove the APP sensor and pedal assembly mounting nuts and detach the assembly from the firewall
Attached to the throttle body
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
The throttle position sensor (TPS) on a 2006 Mustang GT is located on the throttle body, which is situated on the intake manifold. It is mounted directly on the throttle body assembly, typically on the side facing the engine. To access it, you may need to remove some components for better visibility and reach.
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
Surging or stuttering at a particular pedal position such as "the sweet spot" when cursing.
The throttle position sensor is in the throttle body.
the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it
The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.
i found it easier to remove the throttle body to access the tps sensor. the screws can be somewhat difficult to loosen due to corrosion and position of the sensor.
The throttle position sensor is located on the throttle body at the end of the throttle shaft.
The throttle position sensor is located on the throttle plate.