the rear lights are a bit easier. You only need to pull back the carpet in the truck and loosen two butterfly bolts and the rear light assembly will come out. you then remove the individual lights by twisting the lamp a 1/4 turn and pulling it out.
For the front you need to pull the light asembly out and replace the bulb and then pop it back into place. this takes a little more time and care when pulling out.
the flasher that causes the turn signals to flash But where is the flasher located on this car?
Check bulbsCheck fuseCheck turn signal flasher
its under the steering wheel
After replacing the burned out turn signal bulb, turn on the hazard flasher and then turn off the hazard flasher. This will reset the flashing on the turn signal from super fast to standard flashing.
The computer that is attached to the under hood fuse box is the flasher.
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
the turn signal/hazard flasher is located under the dash to the left of the steering column between the brake pedal and the fuse block.
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
Behind center of instrument panel.
the turn signal/hazard flasher is located under the dash between the brake pedal and the fuse block.
Where is the turn signal flasher on a 2002 impala
are you asking about the turn signal bulbs , the turn signal switch or turn signal flasher ?