where can i find the temperture sensor on a ford fiesta 1997
You have to set the belt timing in the VW Citi Golf 1300 without the markings.
The cylinder had bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
45 approx 2001 onwards 1300 engine size ;)
Ignition Timing Initial/Static: 8@Idle C/S
To change the timing belt on a 2006 1300 Ford Bantam, first, disconnect the battery and remove any components obstructing access to the timing belt, such as the engine cover and pulleys. Align the timing marks on the crankshaft and camshaft to ensure correct positioning. Remove the old timing belt, replace it with the new one, and ensure proper tension before reassembling the components. Finally, reconnect the battery and start the engine to verify the installation.
The torque setting for a Ford Fiesta 1300 sump plug is typically around 25 Nm (18 lb-ft). It's important to use a torque wrench for accuracy and to avoid over-tightening, which can damage the oil pan. Always refer to the vehicle’s service manual for the most accurate specifications.
nissan sentrra B13
The Bantam 1300 was made by Ford. Over the years they used three engines, one from the escort, then one from the Mazda 323, then one from the Fiesta. Please can you tell me which engine you have, or what year the car was made might help. Thank you.
I have just had mine done on an R Reg 1300 Fiesta, at Formula One and was charged £260. I must admit that I did'nt shop around as I needed the car Hope this is of some help
I dont know how they changed the purpose of the castles between 1300 and 1400
1300 that's when they changed