You do not charge a battery using a battery eliminator. The eliminator is not a charger, it is an eliminator that allows you to run the device.
That is ridiculous. You cannot charge a battery using paper.
No, you can not charge a mobile battery using torch cell. <<>>> i think charger need and mobile the same. also battery.
You can do both. You can charge while using kindle of u can just charge by not using kindle.
a battery eliminator is an electronic circuit which enables the user to run a device which is normally powered by a battery, by using outlet AC power without having to replace a run down battery. the pros for using a battery eliminator is that the device can run continously without having to replace any battery. the cons of using a battery eliminator is that the portablity / freedom to move anywhere without trailing cumbersome wires is lost. moreover the device should have a builtin receptacle to accept power from a battery eliminator. most importantly the user should preferably use a manufaturer supplied eliminator , since the user then does not have to know all the technical specifications and designs requirements which are needed to make your own battery eliminator. just for info , the following info is a must to construct a battery eliminator. 1 ) The outlet power supply voltage at the place of use & appropriate plug supply cord for the same which will be used to connect the eliminator 2 ) The device DC operating voltage & expected current drain in operation 3 ) The appropriate jack plug which will be suitable for the device and the polarity of the connection , since the output of the eliminator is DC. 4 ) A step down transformer of suitable rating as per points 1 & 2 5 ) Rectifier Diodes , Circuit board to mount the components , Electrolytic cap of rating as may be required with reference to pt.2 The output of stepdown transformer is fed to the rectifier device which converts the AC power available from the transformer to DC. A electrolytic capacitor is used to smoothen out the variations in DC output of the rectifier & make it simulate a constant battery voltage. This description is just for info since it is impossible to give a full construction detail here suitable for any application.
The static-charge eliminator strip or roller.
To charge an LP-E10 battery using a battery charger, follow these steps: Insert the battery into the charger correctly, ensuring the contacts align. Plug the charger into a power source. Wait for the battery to fully charge, indicated by a light or display on the charger. Once charged, remove the battery from the charger. Avoid overcharging to prolong battery life.
There is no safe way to charge ANY battery without a charger rated for that particular battery. You could easily destroy the battery if you try.
If it is an automatic charger let it charge until the charger shuts off.
Do you wish to jump a car with a deep-cycle battery, or do you wish to charge another battery using the deep-cycle battery?
only if the car your using to charge the other on is not started
Yes, if you have a 12 V solar battery charger.
Samsung batteries are quality and will charge well, but it depends more on the type of charger you're using when focuing on battery charge times.