To check the pump on a Little Green Machine, first ensure the unit is unplugged and empty. Inspect the pump for any visible signs of damage or blockage, such as debris or clogs in the hoses. You can also run a test by filling the clean water tank and turning the machine on to see if water is being drawn through the system. If there are issues with water flow, it may be necessary to clean or replace the pump.
Pull very Hard
no, there is not a fuse inside the fuel pump - check to make sure you have 12 volts to fuel pump for first 3 seconds when key is on position- also check ground to fuel pump if both of these are good and you have no or little fuel pump pressure check fuel filter or replace it- if no or little fuel after replacing fuel filter then replace fuel pump also don't forget to check fuel pressure regulator (although this is a rare problem among Chevy Malibu's)
In a top loading machine, remove the front panel. It's easier if the machine is tilted back a little. Under the bottom of the machine, there are two belts, the pump belt and the drive belt. The drive belt is the belt located underneath the pump belt. In a front loading machine, the back panel of the machine must be removed. The belt is located right behind the drum.
Your Hotpoint washing machine may not be draining properly due to a clog in the drain hose or pump, a faulty pump, or a malfunctioning lid switch. It is recommended to check these components and clean or replace them as needed to resolve the issue.
It is located at where the patient's blood is drawn in.
Your washing machine drain may overflow due to a clog in the drain pipe, a malfunctioning pump, or an issue with the machine's water level sensor. It is important to check and address these potential causes to prevent further overflow.
first check to see if fuel filter is clogged.if you have an electric fuel pump, check the fuel pump fuse. next check the fuel lift pump. then check the injector pump
If it's the drain pipe, tilt your machine over and remove it from the pump, clean it out by holding it tight to an outside faucet. -You now need to check the strainer/filter in the floor of the machine, it may be broken.
Check the fuel pump or the fuel pump relay
check for voltage back where the hot wire connects to the fuel pump. also check groundwire off fuel pump. check fuel pump fuse / check fuel pump relay.
Your washing machine drain may overflow due to a clog in the drain pipe, a malfunctioning pump, or an issue with the water level sensor. It is important to check and address these potential causes to prevent further overflow.
Your Keurig may be making noise but not brewing due to a clog in the machine, a problem with the water pump, or a malfunction with the brewing mechanism. It is recommended to clean the machine, descale it, and check for any blockages to resolve the issue.