0
What else can I help you with?
What is the firing order for a 1983 jaguar XJ6?
What is the firing order of a 1983 Jaguar XJ6 dist. cap order. Its 1,5,3,6,2,4 if my memory works.
Where is the 1 cyl on an 1984 Fiero dist cap?
The firing order on a 2.5 Pontiac motor is 1-3-4-2, 1 being in front. The chilton book shows the firing order and the wire placement on the dist cap. #1 is at 10 oclock.
What is the firing order for 1991 sonoma dist cap?
1-5-3-6-2-4
Firing order on dist cap 1988 2.8 v6?
1-4-6-3-2-5
What is the firing order for the spark plugs in a 1997 Jeep Wrangler Sahara?
The firing order is 153624 #1ON DIST-CAP IS JUST AFTER LOCKING SCREW FERVEST FROM THE CYLINDER HEAD.
What is the firing order for 89 350?
1-8-4-3-6-5-7-2 clock wise on dist. cap.
What is theFiring order distributor cap for a 1973 dodge charger with a 400?
the firing order is 18436572. The Distributor location of no 1 is usually on the front to the right of the Dist. hold down clip. But, that can be changed depending on where you locate the Dist. in the block.
Firing order for 1973 Chevy 350 smallblock?
1-8-4-3-6-5-7-2 clockwise on the dist. cap
Do you have schematic for the firing order for a 1993 Chevrolet Suburban?
the firing order is 1-8-4-3-6-5-7-2. Number one cylinder on the cap should be slightly to the right of center on the front of the dist cap. Firing order will go in a clockwise motion around the cap. CYLINDERS 8 7 6 5 4 3 2 1 front of car
1999 5.7 liter Chevy firing order dist cap Chevy?
Clockwise--1-8-4-3-6-5-7-2
What is the firing order on the distributor cap for a 1990 Chevrolet 1500 5.0l?
The firing order on all small block chevys is 18436572. It should be imorinted on the intake. Trace the number one plug wire back to the dist. It's the one on the left (drivers) side of the engine at the front of the motor. The dist rotates clockwise.
How do i know where to put the firing order on the distributor cap?
After bringing your engine to top dead center, line the distributor up so the rotor faces the number one cylinder. Rotate the dist. so the closest terminal lines up with the rotor. This will be your number one in your firing order. Mark that terminal #1. Tighten the dist. in place. Put your wire from the cap to #1 cyl. Now follow the firing order for the rest of the wires. The dist. rotates clockwise so put the wire on the next terminal on the left and route it to the next number cyl. in the firing order. Do this till all are connected. Here is a link to help. http://www.classiccarauto.com/impala/how_to/install_distributor.shtml
