answersLogoWhite

0

Open or pull the plug on it

User Avatar

Wiki User

8y ago

What else can I help you with?

Related Questions

What is the pH level of drain cleaner?

Drain cleaners are typically very basic, with a pH level ranging from 12 to 14.


How many plate tectonics were there?

14


What are the ratings and certificates for Animalia - 2007 Brain Drain 1-14?

Animalia - 2007 Brain Drain 1-14 is rated/received certificates of: Australia:G


What is the pH in Drano?

To answer this question we would need to know the type of drain cleaner you are referring to. If you are talking about liquid drain cleaner it has a pH of 14. But the pH ranges from 13 to 14 depending on the type.


When was the plate freezer patented?

10/14/1924


It takes 100 000years for a plate to move about 14 kilometers calculate the rate if plate motion?

To calculate the rate of plate motion, divide the distance traveled by the time it took to travel that distance. In this case, the rate of plate motion is 14 kilometers divided by 100,000 years, which equals 0.00014 kilometers per year.


What are the shapes of the 14 most important plates?

The Earth's 14 major tectonic plates include the Eurasian Plate, North American Plate, South American Plate, African Plate, Antarctic Plate, Indo-Australian Plate, Pacific Plate, Nazca Plate, Arabian Plate, Philippine Sea Plate, Scotia Plate, Cocos Plate, Caribbean Plate, and Juan de Fuca Plate. These plates vary in shape and size, but most are large, irregularly-shaped sections of the Earth's lithosphere that fit together like a jigsaw puzzle to form the Earth's surface.


Where is the thermostat and how to change it on a 1993 Subaru legacy?

thermostat is located behind the lower radiator hose (low). there is two or three bolts that hold the thermostat housing to the engine block. the thermostat is behind it. you can drain the radi. threw the drain or just remove hose clamp and pull off hose. lots of coolant, little messy but quick. after you remove the old thermostat remember how it came out. make sure the area the t-stat sits in is clean. replace with new t-stat and reassemble. carefully tightening bolts, 14-18 foot pounds. get bolts tight and give a good snug. would recommend replacing coolant lost with new coolant. if not sure what kind , just use universal coolant


What are the release dates for Nailed at the Plate - 1918?

Nailed at the Plate - 1918 was released on: USA: 14 October 1918


How do you change coolant 1995 lexus ls400?

1. Remove the V-Bank cover. 2. Drain the engine coolant. 3. Remove the radiator cap from the radiator reservoir. Caution: To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot, as fluid and steam can be blown out under pressure 4. Remove the water filler plug from the throttle body. 5. Remove the 3 drain plugs on the engine and radiator, and drain the coolant. 6. Close the 3 drain plugs. Tighten the drain plug to 108 inch lbs. (12.7 Nm). 7. Refill with engine coolant. 8. Slowly fill coolant to the throttle body until it is full. Note: Use of improper coolants may damage engine cooling system. Note: Use "Toyota Long Life Coolant" or equivalent and mix it with plain water according to the manufacturer's directions. 9. Use of the coolant which includes more than 50% (freezing protection down to −31°F (−35°C)) or 60% (freezing protection down to −58°F (−50°C)) of ethylene−glycol is recommended, but not more than 70%. Note: Do not use an alcohol type coolant or plain water alone. The coolant should be mixed with plain water (preferably demineralized water or distilled water). Capacity (w/ Heater): 11.6 qts 10. Install the water filler plug to the throttle body. Tighten plug to 33 ft. lbs. (45 Nm). 11. Slowly pour coolant into the radiator reservoir until it is "FULL". 12. Install the radiator cap. 13. Bleed the cooling system. 14. Start the engine, and open the heater water valve. 15. Maintain the engine speed at 2,000 − 2,500 rpm, and warm up the engine. 16. Stop the engine, and wait until the engine coolant cools down. 17. Refill coolant into the reservoir until it is "FULL". 18. Check engine coolant for leaks. 19. Check engine coolant specific gravity correctly. 20. Reinstall the V-Bank cover.


Drain plug for automatic transmission on 1990 miata?

My 93 only had a pan and no drain plug. I had to remove 14 screws and drop the pan.


What is the torque specs for the pressure plate on a suzuki samurai?

Pressure plate to flywheel torque is (ft lbs) 14 to 20.