first try changing the oil and fillter in the transmission then refill with properamout of oil and add lucas oil treatmet aswell ajust the bands in the trans ...
hope this helps
AnswerChances are it is in "limp home mode" brought on by the computer that senses transmission problems. Take it to a shop.To adjust the transmission cable in a Dodge Shadow, first, locate the cable linkage on the transmission. Then, loosen the adjustment nut on the cable. Shift the transmission to the "Park" position, pull the cable to take up any slack, and tighten the nut to secure the adjustment. Finally, test the gear selection to ensure proper function.
To change the transmission pan gasket on a 1991 Dodge Shadow, first, safely lift the vehicle and support it on jack stands. Drain the transmission fluid by removing the drain plug or loosening the transmission pan bolts, allowing the fluid to flow out. Remove the transmission pan by unbolting it, clean the mating surfaces, and install the new gasket. Reattach the pan, torque the bolts to the manufacturer’s specifications, and refill the transmission with the appropriate fluid.
If your 1991 Dodge Shadow won't go into reverse, it could be due to several issues, such as low transmission fluid, a faulty transmission linkage, or worn internal components. First, check the transmission fluid level and quality; low or dirty fluid can hinder proper function. If the fluid is fine, inspect the linkage for any misalignment or damage. If those steps don’t resolve the issue, it may be necessary to consult a mechanic for a more in-depth diagnosis.
The Hemi wasn't an option in a 2002 Dodge Ram. It was first offered in the 2003 model year, and a manual transmission was an option.The Hemi wasn't an option in a 2002 Dodge Ram. It was first offered in the 2003 model year, and a manual transmission was an option.
if spedo dont work ether its a speed sensor
What year, make and model? Is it Ratchet top, Turtle Top, Sportster, or Evo?
check the fluid level
located in the transmission oil pan. unbolt pan and it will be visible. may want to drain transmission first though. = )
If it is a transmission problem- First step would be to change trans. fluid and filter If it is a transmission problem- First step would be to change trans. fluid and filter
First check the linkage for the 2000 Dodge Neon transmission to make sure that it is fully going into reverse. If it is, then the transmission needs to be taken out and pulled apart to see what internal parts have failed, and how to fix it.
To remove the transmission from a Dodge Ram diesel, first, ensure the vehicle is on a level surface and safely supported with jack stands. Disconnect the battery, then drain the transmission fluid and remove the drive shafts. Next, detach the transmission crossmember, shift linkage, wiring harness, and any coolant lines. Finally, unbolt the transmission from the engine and carefully lower it using a transmission jack.
Could be either, check the fluid first.