A code P0400 on a Geo Tracker indicates an issue with the Exhaust Gas Recirculation (EGR) system, typically related to flow problems. To fix this, start by inspecting the EGR valve for blockages or damage, and clean or replace it if necessary. Check the EGR passages and vacuum lines for any obstructions or leaks, and ensure the EGR control solenoid is functioning properly. After addressing these components, clear the code and test drive the vehicle to see if the issue persists.
The code P0 400, in your Chevrolet Geo tracker, is a reference to the ABS braking system not working properly. In most cases when the ABS braking system is not working properly you will need to change the sensor.
Locked meaning blown?,no quick fix.
what the hell is cas
buy a new one
you replace it
The IAT Sensor on a 1992 Geo Tracker is the Intake Air Temperature Sensor. Replacing the air filter might fix this problem.
Repair kit availale at most auto parts stores
Disconnect the negative cable from the battery for about one minute and the light goes off, if the light comes on again you must use an scanner and find out which code you have to fix the sensor that sends that code from emissions system.
Sounds like your bands are shot, this is an expensive repair.
You must have to get a new or used (acceptable condition)rotor or hub if separated.
Code P0400 means EGR insufficient or excessive flow detected Code P0440 means Evap system leak
code 22 needs (engine coolant temperature sensor replaced) don't know about the 25