0
You more than likely have a defective unit. i own a '93 new yorker and my abs lights were lit on my dash, a few days later my brakes completely failed. ABS HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR CAUSING PUMP-MOTOR DETERIORATION.
there is an open recall on this part, i got it replaced for free (a several thousand dollar job) less the cost of a diagnostic computer fee. here's a link with more info: http://www.motortrend.com/cars/1991/Chrysler/new_yorker/recalls/index.html http://www.internetautoguide.com/auto-recalls/09-int/1993/chrysler/new-yorker/index.html
although the model year is '91 for the link ik believe they were still using the same abs assembly in 93. hope this helps.
What else can I help you with?
Abs light stays on in a Chrysler grand voyager?
Have a Chrysler diag. it with a scan tool. The good news that the brake system will still work as if there were no ABS system
Location of ABS pump on a 1993 Chrysler town and country?
If equipped with abs the pump is located on top of the transmission.
Where is the computer located on a 1994 chrysler new yorker?
Engine, transmission, and ABS are under the hood. Airbag, body, HVAC, RKE, are inside or under the dash.
Where is the ABS relay switch on a 1989 Chrysler new yorker landau?
The ABS relay switch on a 1989 Chrysler New Yorker Landau is typically located in the engine compartment, near the power distribution center or fuse box. It may also be found mounted on the driver's side fender or near the ABS pump. To access it, you may need to remove any covers or panels that obstruct the area. Always refer to the vehicle's service manual for precise locations and diagrams.
Does your 91 new yorker have a vacuum on the master cylinder?
The brake booster will have a vacuum line going to it on a non abs system.
How do you know if a 2000 chrysler cirrus has ABS?
The abs system will have wiring going to the wheel bearings for the speed sensors.The abs system will have wiring going to the wheel bearings for the speed sensors.
Why would your anti lock light stay on your 1993 Lincoln town car?
The ABS light is on because there is a problem with the ABS system. The ABS light will remain on until it is fixed. The ABS system will not function as long as the ABS light remains on.
Where are Speed sensors on Chrysler new yorker?
In a Chrysler New Yorker, speed sensors are typically located on the transmission. Specifically, the vehicle may have a vehicle speed sensor (VSS) mounted on the transmission case, which detects the speed of the output shaft. Some models may also have additional sensors in the differential or wheel speed sensors for the anti-lock braking system (ABS). Always consult the vehicle's service manual for precise locations based on the specific model year.
What does the abs warning mean on a 2003 Chrysler town and country?
The light is on because the abs computer has detected an electrical failure. You need to have the system checked for codes.
Can you replace abs with non-abs master cylinder like installing regular master cylinder and disabling abs on 92 Voyager and is the master cylinder used with the abs different from that used without?
if this is the same abs system that i am thinking.....Chrysler issued a lifetime warranty on the entire abs hydraulic system . Call your local dealer with the VIN # to confirm.
How do you reset the abs light on a 1998 Chrysler Sebring?
unhook battery cables for five or six, but the problem will come back because if the light is on there is fault in the ABS system
Why a 1995 Chrysler lebaron gtc has the Abs light on?
The abs light will stay on when the computer detects a malfunction and sets a code. You need to have the system checked with a scan tool.
