To flush the coolant system on a 2004 GSXR 600, start by ensuring the engine is cool. Remove the radiator cap and drain the old coolant by loosening the drain bolt at the bottom of the radiator. Once drained, flush the system with clean water until it runs clear, then close the drain bolt. Refill with a proper mix of fresh coolant and distilled water, bleed the system to remove any air pockets, and replace the radiator cap.
You cannot modify a 2007 GSXR motor in a 2004 GSXR frame.
yes it will
(2.3/1.9 US/lmp qt)
Hold the bike level and check the coolant bottle behind the lower left fairing.
2004
To check the coolant level on a 2007 GSXR 600, first ensure the bike is on a level surface and the engine is cool. Locate the coolant reservoir, which is typically found on the right side of the bike, near the radiator. The reservoir should have markings indicating the minimum and maximum levels; visually inspect the coolant level against these marks. If the level is low, you can add the appropriate coolant mixture as needed.
They are restricted to 186mph in the UK
i ran my 2004 gsxr 1000 Matt madlin limited edition on the 1/4 mile strip and ran a 10.030 dam close to a 9 second bike
Fit a power commander and get it Dyno'd.
The radiator cap is under the gas tank at the front. There is also a coolant recovery tank located under the passenger seat on the left side.
ya. i did it on my bike. as long as its the same year
16 teeth in the front 45 teeth in the rear