answersLogoWhite

0

After repairing the cause of the code, you can clear it with a scan tool.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you get rid of the oil warning light on 2001 vw golf.?

Add oil!


What causes the yellow check light of 2003 Honda accord to come on?

The check engine light on a 2003 Honda Accord will be triggered when something on the engine is malfunctioning. To rid the check engine a light the ECU will need to be reset.


How do you get rid of moisture in mark 3 back lights?

drill a very small hole on bottom of the light


Mustang check engine light 0442 - How do I get rid of it?

Unplug the battery for like 45 secs.


How do you get rid of service engine soon light on a2002 Nissan Sentra?

Take it to a shop and get the engine serviced. Kinda makes sense if you think about it.


What is a mark?

a nuisance to get rid of


How do you get rid off the engine light in a Kia Rio?

Try disconnecting the battery for about 10 mins. or have vehicle scanned to determine the problem, engine light also comes on when gas is pumped while car is on sometimes


How do you get rid of check engine light after changing oil in a 2011 6.7 powerstroke?

The check engine light is causes by an emission system failure. If the cause of the code has been repaired, the code can be cleared with a scan tool.


How do i reset check engine light on 2016 kenworth w900?

You can disconnect your batteries for about 30 minutes, and it'll reset the ECM and the check engine light will be gone... momentarily, until the next diagnostic runs and the same fault is detected. You want to get rid of the check engine light, you find out the reason why and have it fixed.


How do you get rid of a check engine light?

To get rid of a check engine light, first, use an OBD-II scanner to read the diagnostic trouble codes (DTCs) and identify the underlying issue. Address the problem, which may involve repairing or replacing faulty components, such as a sensor or ignition system. After resolving the issue, you can reset the check engine light by disconnecting the battery for a few minutes or using the scanner's reset function. If the light persists, consult a mechanic for further diagnosis.


How To Get Rid Of A Beauty Mark?

You can't


How do you reset the check engine light in a 1998 integra?

Go to the fuse that is on the battery terminal, and remove it for about 20 seconds, then put it back in. This will reset the ECU which will rid you of the check engine light. If the problem that caused the light to come on is still present the code will be set in the ECU and the check engine light will be turned on again until the problem is corrected.