remove back covered area and use jack to reel tire down.
To change the spare tire on a Chrysler Pacifica, first ensure the vehicle is on a flat surface and engage the parking brake. Loosen the lug nuts slightly, then use a jack to lift the vehicle until the flat tire is off the ground. Remove the lug nuts completely, take off the flat tire, and replace it with the spare tire, tightening the lug nuts by hand. Finally, lower the vehicle back to the ground and securely tighten the lug nuts in a crisscross pattern.
Hi, The spare tire is underneath the rear of your Pacifica. However, to lower it, you will have to open the back hatch and open the floor compartment. In the middle of the compartment you will see a place where you have to fit the lug wrench onto. Then after it is fitted on, you will have to keep spinning the lug wrench to the left until the spare tire is lowered onto the ground. Then you will have to release the cable that lowered the spare tire down from the vehicle. Next, take the flat tire off and install the spare tire. Then take your flat tire to the nearest decent tire store or car garage and have them either fix the flat, or replace the tire if it is ruined. Then after you get the tire back, take the spare off and put the good tire back on again. Happy Traveling!
To reset the tire pressure light on a Chrysler Pacifica, first ensure that all tires are inflated to the recommended pressure, including the spare tire if applicable. Then, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. The tire pressure light should turn off if the system recognizes the correct tire pressures. If it remains on, you may need to drive the vehicle for a few minutes to allow the system to recalibrate.
Chrysler does not use inertia/cut off switches.
put it on
Wear it!
There isnt a spare tire on a ssr. If you want one you need a spare off of a envoy or trailblazer.
Check the spare tire sensor.
chanching rotors on a pacifica is simple pull out the cotter pin in the middle and the rotor should come right off
Have you checked the spare tire yet? I hear that if the spare is too low the light will stay on.
Chrysler does not use shutoff or inertia switches.Chrysler does not use shutoff or inertia switches.
You can not disable it. You have to fix whatever is causing it to go off.