try clening the contacts with emmery cloth that should do it.
Take out the spark plugGet a lighter and light the silver part of the spark plugAfter that kick the dirt bike over about 5-6 times.If that still does not work repeat number 1 and 2 and get a mini torch and get the spot on fire where u put the spark plug while on fire kick the kick start over a few times and put the spark plug back in if that does not work u need a new spark plug.....happens to my KTM 65 2000 all the time!!
You need to add the oil in the correct mixture you should have added in the first place. You may also need to remove the spark plug and spray a little WD40 in the cylinder and replace the plug. This should get the bike to start.
spark plugs tend to foul because too much oil builds up around the plug and it cannot work correctly. *sometimes* you can actually remove the plug, clean it, re-gap it, and replace it in the bike.
add itr bton the plug
The device that ignites gas in a car engine is the spark plug. The spark plug will not work without a device, called a coil, that sends a signal to the spark plug to tell it when to spark.
It won't.
anywhere between 16 and 18 on a spark plug gauge should work fine.
The spark plug gap for an AR135 spark plug on a 350 SBC should be set at .034 inches. This is equal to .86 mm so a spark plug set to .9 mm should work correctly.
They will not reach the plug, therefore the engine will not work.
Actually , there are no spark plugs in a diesel engine
Champion RJ19LM will work.
Hello just picked one of these bikes up for my girlfriend to start out with its a pretty cool bike. The gap is .6 to .7 using a gnk plug metric bike. This one was burning rich and had a hard time with smooth idle any ideas? Hello great starter bike the gap is .6 to .7 gnk plugs work the best and the heat of the plug might have to be changed to make the bike run better.